Loading ...
Loading ...
Loading ...
9. Movethrottleleverto"Fast"position,shownhere
asa rabbit.
10.Movechokeleverto"Choke"position.
NOTE:Forawarmengine,besurethechokeleveris
in the"Run"position.
11.Grasphandleandpullrecoilstarterlightlyuntilyou
feelsomeresistance,thenpullbriskly.
wAR.a.G ]
When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze
trigger on spray gun.
2. Return recoil starter slowly. DO NOT let rope
"snap back" against starter.
13. When engine starts, slowly move choke lever to
"Run" position as engine warms, if engine falters,
move choke lever to "Choke" position, then to
"Run" position.
14. if engine fires, but does not continue to run,
squeeze trigger on spray gun to relieve internal
pump pressure. Move choke lever to "Run"
position, and repeat steps 11 through 13.
IMPORTANT: If engine floods, place choke lever in
"Run" position and crank until engine starts.
NOTE: Always keep the throttle lever in the "Fast"
oosition when operating the pressure washer.
DO NOT touch hot surfaces.
Allow equipment to cool before touching.
The pressure washer must be at least 5 feet from structures
having combustible walls and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance and servicing.
In the State of California a spark attester is required by law
(Section 4442 of the California Public Resources Code). Other
states may have similar laws. Federal laws apply on federal
lands, if you equip the muffler with a spark attester, it must be
maintained in effective working order.
How to Stop Your C_eaning System
1. Let engine idle for two minutes.
2. Move throttle lever on engine to "Stop" position.
CAUTION
DO NOT stop engine by moving choke lever to "Choke"
position. Backfire, fire or engine damage could occur.
3. Squeeze trigger on spray gun to relieve
trapped pressure in hose to avoid injury.
NOTE: A small amount of water will squirt out when
3ressure is released.
WARNING
Keep high pressure hose connected to pump and spray
gun while system is pressurized.
Squeeze trigger on spray gun to relieve trapped
pressure, every time you stop engine. Engage trigger
lock on spray gun.
4. Rotate the Dial-A-Cleaner TM selector knob to
the OFF position to prevent chemicat leakage.
5. Engage trigger lock on spray gun when not in use.
How to Use Accessory Tray
The unit is equipped with an accessory tray with
places to store your ProjectPro TM nozzles, spray gun
and nozzle extension.
NOTE: The extra hole in the tray is for storing a utility
brush. The extra clip in the tray is for storing a turbo
nozzle. The brush and turbo nozzle are NOT included
with your pressure washer. You can buy these items
as optional accessories.
1. Place nozzle extension through hole on accessory
tray, as shown.
2. Place spray gun through hole on accessory tray
on right side of unit.
3. Insert multi=colored ProjectPro TM nozzles in
spaces provided in accessory tray.
10
Loading ...
Loading ...
Loading ...