Euromaid GDW45S-2 45cm Slimline Freestanding Dishwasher

Never run the dishwasher without the filters in place. When cleaning the filters, don't knock on them. Otherwise, the filters could

be contorted and the performance of dishwasher could be debased.

Cleaning the Spray Arms

It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets and bearings. To remove the

spray arms, screw off the nut clockwise to take out the washer on top of the spray arm and remove the arm. Wash the arms in

soapy and warm water and use a soft brush to clean the jets. Replace them after rinsing thoroughly.

Caring for the Dishwasher

To clean the control panel, use a lightly dampened cloth then dry thoroughly.

3. Drain water from the inlet pipe and water valve. (Use a pan to catch the water)

4. Reconnect the water inlet pipe to the water valve.

5. Remove the filter in the tub and the bottom and use a sponge to use up water in sump

Cleaning the Door

To clean the edge around the door, you should use only a soft warm, damp rag. To prevent penetration of water into the door lock

and electrical components, do not use a spray cleaner of any kind. Also, never use abrasive cleaners or scouring pads on the outer

surfaces because they will scratch the finish. Some papers towels can also scratch or leave marks on the surface.

Never use a spray cleaner to clean the door panel for it could damage the door lock and electrical components. It is not allowed to

use the abrasive agent or some paper towels because of the risk of scratching or leaving spots on the stainless steel surface.

To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products. Use only a cloth and

warm soapy water. To remove spots or stains from the surface of the interior, use a cloth dampened with water and a little white

vinegar, or a cleaning product made specifically for dishwashers.

When You Go on holiday

When you go on holiday, it is recommended that you run a wash cycle with the dishwasher empty and then remove the plug from

the socket, turn off the water supply and leave the door of the appliance slightly ajar. This will help the seals last longer and

prevent odors from forming in the appliance.

Moving the Appliance

If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary, it can be positioned on its back.

Seals

manual is kept with the machine, so that the new owner may benefit from the advice contained within it.

Please read this instruction manual carefully: it contains important information regarding the safe installation, use and

maintenance of the appliance.

If the appliance must be moved at any time, keep it in an upright position; if absolutely necessary, it may be tilted onto its back.

2. Check the dishwasher by placing it so that its sides or back panel are in contact with the adjacent cabinets or even with the