Loading ...
Loading ...
Loading ...
I 1=800=944=9044 (United States) Visit our web site at
1-800-265=8352 (Canada) www.frigidaire.com.
PROBLEM CAUSE i CORRECTION
AUTOMATIC ICE MAKER
Ice maker is not mak= . Ice maker wire signal arm is in
mg any ice. the "up" or OFF position.
• Ice maker power switch is Off.
• Ice maker has small cube
caught in mechanism.
• Saddle valve on cold water
pipe is clogged or restricted by
foreign material.
Irce maker is not mak'. ice maker is pr0dudng less ice
ing enough ice, than you expect.
I
Check to see if water dispenser
is dispensing slower than normal
Ice maker will not stop • Ice maker wire signal arm is
making ice. being held down by some item
in the freezer.
• Move wire signal arm to the "down" or ON position. (side
mounted)
• Turn power switch to On ("I') position. (rear mounted)
• Remove small cube from ice maker. The ice and water
filter cartridge may be clogged. Replace filter cartridge.
• Turn off household water line valve. Remove valve. En-
sure that valve is not a self-piercing saddle valve. Clean
valve. Replace valve if necessary.
Side mounted iC_ maker should produce 4 to4.5 pounds
(approximately 4 quarts) of ice every 24 hours, A rear
mounted ice maker should produce 3 to 4 pounds (ap-
1
proximately 3V2 quarts) of ice every 24 hours. Quick Ice
option should produce up to 50% more ice every 24 hours.
• If it is, replace the ice and water filter cartridge
• Move item and release wire signal arm. Remove any ice
cubes that are frozen together over the wire signal arm.
Ice Cubes arefreezing_ ' Ice cubesar_ nOt-being Used ' • Remove ice €ontainer and discard ice from container,ice_
together, frequently enough, maker will produce fresh supply.
• Ice cubes are hollow (partially • The ice and water fi!ter cartridge may be clogged, Replace
. frozen cubes with water inside), filter cartridge.
. e Freezer control is set too warm.. * Set freezer control to colder settingl AII0w 24 hours for
, temperature to stabilize.
ICE DISPENSER
Dispenser will not dis'
=
pense =ce.
• Household water line valve is
not openl
' _ ice dispensing arm has been held
in for more than 4-5 minutes.
Ice dispenser is • Ice has melted and frozen
jammed, around auger due to infrequent
use, temperature fluctuations,
and/or power outages.
• Ice cubes are jammed between
ice maker and back of ice
container.
m
. When the fir_ Supply Of ceis dropped int0 the conta net,
the dispenser shou!d operate.
• Turn freezer control to a higher setting so that ice cubes
will be made. When first supply of ice is made, dispenser
should operate.
• Open household water line valve. Allow suffident time
for the ice tobe made. When ice is made, the dispenser
should operate.
• Motor is overloaded. Motor over load protector will reset in
approximately 3 minutes. Ice can then be dispensed.
• Remove ice container, thaw, and empty the contents.
Clean container, wipe dry, and replace in proper position.
When new ice is made, dispenser should operate.
• Remove ice cubes that are jamming the dispenser.
OPENING / CLOSZNG OF DOORS/ DRAWERS
Door(s) will not close. • Door was closed too hard, caus-
ing other door to open slightly.
• Refrigerator is not level. It
rocks on the floor when moved
slightly.
• Refrigerator is touching a wall
or cabinet.
Drawers are difficult to ' Food is touching shelf on top of
move: drawer.
Q Track that drawers slide on is
• Close both doors gently.
• Ensure floor is level and solid, and can adequately support
the refrigerator. Contact a carpenter to correct a sagging
or sloping floor.
• Ensure floor is level and solid, and can adequately support
the refrigerator. Contact a carpenter to correct a sagging
or sloping floor.
Remove t0p !ayei Of items in drawer.
• Ensure drawer is properly installed on track.
• Clean drawer, rollers, and track, See Care & Cleaning,
Loading ...
Loading ...