Loading ...
Loading ...
Loading ...
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position. Remove the
wire tie from the power cord.
Lock the cord into
place by forcing it into
the locking notch on
the body of the quick
release upper cord
hook as shown. This
helps keep the power
cord out from under
the vacuum cleaner
agitator.
Loekin(
Power
Upper Cord
Hook
Cord
Lower
Cord
Wrap the power cord around the upper and
lower cord hooks an_J.lock the power cord
plug onto the power cord.
POWER-MATE JR.®
For operation of Power-Mate Jr.® see
seperate owners manual.
Power-Mate Jr.®
Tab
Latch
Caddy
TO INSERT POWER-MATE JR ®
Place the rear of the Power-Mate Jr ®into
the caddy
Rotate the Power-Mate Jr.® back until it
snaps into place.
TO REMOVE POWER'MATE JR.®
Lift up on the latch and rotote Power-Mate
Jr. ®out of the caddy.
HOW TO START
Release
Hook
1. Turn the
quick release
upper cord
hook clock-
wise to
release the
power cord.
2. Release the power cord plug from the
power cord and pull the cord off the quick
release upper cord hook. Check to be sure
the power cord is still locked into the lock in
the quick release upper cord hook.
3. Check to see if the cleaner has bag
installed. See DUST BAG CHANGING.
Note: To reduce the risk of electric shock,
this vacuum cleaner has a polarized plug,
one blade is wider than the other.
This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit,
contact a qualified technician to install the
proper outlet. Do not change the plug in any
way.
4. Plug the polarized power cord into a 120
Volt outlet located near the floor.
6
5. To replace cord, turn upper hook counter-
clockwise pointing up, then wrap cord.
E
WARNING
Personal Injury and Product Damage
Hazard
• DO NOT plug in if switch is in the ON
position. Personal injury or damage
could result.
• DO NOT use outlets above counters.
Damage from cord to items in surround-
ing area could occur.
Loading ...
Loading ...
Loading ...