Loading ...
Loading ...
Loading ...
3
WA R N I N G
HOW TO CONNECT ELECTRICITY
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE GROUND PRONG FROM THE
POWER CORD. FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.
• The power cord from this appliance is equipped with a grounding plug which minimizes the possibility of electric
shock hazard
.
• Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
• It is your personal responsibility and obligation to have your outlet replaced with the properly grounded wall
outlet.
• The refrigerator should always be plugged into its own individual dedicated electrical circuit, which has a volt
age
rating that matches the rating plate. This provides the best performance and also prevents overloading building
wiring circuits which could cause a fire hazard from overheated wires or tripping a circuit breaker / blowing
a
protective fuse.
• Never unplug the equipment by pulling on the power cord. Always grip plug firmly and pull straight out from the
outlet.
• Repair or replace immediately all power cords that have become frayed or otherwise damaged.
• Do not use a cord that shows cracks or abrasion damage along its length or at either end.
• When removing the equipment away from the wall, be careful not to roll over or damage the power cord. If
power cord is damaged it should be replaced with original equipment manufacturer parts. To avoid hazard this
should be done by a qualified service technician.
• Do not plug the power cord into an extension cord. This can create a fire hazard or short circuit.
WA R N I N G
Compressor warranties are void if compressor burns out due to low voltage.
Power supply cord ground should not be removed!
Do not use electrical appliances inside the compartments of this equipment.
TRANSPORTATION AND INSTALLATION
1. When you transport the freezer, the angle between the compartment body and the
ground should be no more than 45°, and you should never place the freezer up-side down.
2. Do not use any of the external part as loading points, for example, the condenser on the
back, the door or the hinge.
3. When the freezer is installed or used, all the package (including board and foam plastic)
should be properly disposed of. Please recycle, when possible.
4. Keep the freezer stable and level to avoid vibration and noise.
5. The freezer should be installed in a place with good ventilation, a space of at least 4" (10cm) should be allowed
between the surrounding walls and the cabinet wall for proper air circulation.
6. It should be placed far from any heat source and not under direct sunshine to avoid less efficient performance due
to the high ambient temperature.
7. Install the freezer in a dry place to prevent the compartment body from rusting, which may (1) affect the electri
c
insulation (2) create a food safety contamination risk and (3) reduce the appliance's expected useful life.
CAUTIONS:
1. The freezer must be properly grounded to avoid a shock hazard.
2. In case of any damage to the electric wires and/or plug, please contact an authorized electrician to repair the
connection.
3. If the voltage is unstable, please provide a suitable automatic voltage regulator and/or surge protection.
4. Allow the freezer to reach its operating temperature before it is loaded with product.
5. You shoul d adjus t the t em perat ure con trol ac cordi ng to t he requ ired temperature and quantity/tiers of the stor
ed
Loading ...
Loading ...
Loading ...