Loading ...
Loading ...
Loading ...
TROUBLESHOOTING CHART:
PROBLEM CAUSE CORRECTION
Will not start
Hard to start
Engine will not
turn over
Engine clicks but
will not start
Loss of power
Excessive vibration
1 Out of fuel.
2 Bad spark plug.
3 Dirty air filter.
4 Water in fuel.
5 Loose or damaged wiring.
6 Engine valves out of adjustment.
1 Dirty air filter.
2 Bad spark plug.
3 Weak or dead battery.
4 Stale or dirty fuel.
5 Loose or damaged wiring.
6 Engine valves out of adjustment.
1 Clutch/brake pedal not depressed.
1 Fill fuel tank.
2 Replace spark plug.
3 Clean/replace air filter.
4 Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
5 Check all wiring.
6 Contact a qualified service center.
1 Clean/replace air filter.
2 Replace spark plug.
3 Recharge or replace battery.
4 Empty fuel tank and refill tank
with fresh, clean gasoline.
5 Check all wiring.
6 Contact a qualified service center.
1 Depress clutch/brake pedal.
2 Deck clutch is engaged.
3 Weak or dead battery.
4 Blown fuse.
5 Corroded battery terminals.
6 Loose or damaged wiring.
7 Faulty ignition switch.
8 Faulty solenoid or starter.
2 Disengage deck clutch.
3 Recharge or replace battery.
4 Replace fuse.
5 Clean battery terminals.
6 Check all wiring.
7 Check/replace ignition switch.
8 Check/replace solenoid or starter.
9 Faultyoperatorpresenceswitch(es).
1 Weak or dead battery.
2 Corroded battery terminals.
3 Loose or damaged wiring.
4 Faulty solenoid or starter.
1 Cutting too much grass/too fast.
2 Build-up of grass, leaves and trash
9 Contact a qualified service center.
1 Recharge or replace battery.
2 Clean battery terminals.
3 Check all wiring.
4 Check/replace solenoid or starter.
1 Raise cutting height/reduce speed.
2 Clean underside of mower
under mower.
3 Dirty air filter.
4 Low oil level/dirty oil.
5 Faulty spark plug.
6 Stale or dirty fuel.
7 Water in fuel.
8 Spark plug wire loose.
housing.
3 Clean/replace air filter.
4 Check oil level/change oil.
5 Clean & regap or changespark plug.
6 Empty fuel tank and refill tank
with fresh, clean gasoline.
7 Empty fuel tank and carburetor,
refill tank with fresh gasoline.
8 Connect & tighten spark plug wire.
9 Dirty engine air screen/fins.
10 Dirty/clogged muffler.
11 Loose or damaged wiring.
12 Engine valves out of adjustment.
1 Worn, bent or loose blade.
2 Bent blade mandrel.
3 Loose/damaged part(s).
9 Clean engine air screen/fins.
10 Clean/replace muffler.
11 Check all wiring.
12 Contact a qualified service center.
Replace blade. Tighten blade
1 bolt.
2 Contact a qualified service center.
3 Tighten loose part(s).
Replace damaged parts.
25
Loading ...
Loading ...
Loading ...