Loading ...
Loading ...
Loading ...
Before Your First Cookout
• Light burners, check to make sure they are lit, close the lid and
warm up grill on HIGH for 15 minutes. This curing of paint and
parts will produce an odor only on first lighting.
Burner Flame Check
• Light burner, rotate knobs from HIGH to LOW.You should see
a smaller flame in LOW position than seen on HIGH. Always
check flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the Troubleshooting Section.
Hose Check
• Before each use, check to see if hoses are cut, worn or kinked.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified in the Parts List.
Normal Kinked
Hose Hose
Turning Grill Off
• Turn all knobs to OFF position. Turn LPtank off by turning
OPD handwheel clockwise to a full stop.
Ignitor Check
• Turn gas off at LP tank. Push and turn burner control to _, .
"Clicking" should be heard and sparking seen each time
between collector box or burner and electrodes. See
"Troubleshooting" if no click or spark occurs.
Valve Check
• Important: Make sure gas is off at LP tank before checking
valves. Knobs lock in OFF position. To check valves, first
push in knobs and release, knobs should spring back. If knobs
do not spring back, replace valve assembly before using grill.
Turn knobs to LO position then turn back to OFF position.
Valves should turn smoothly.
General Grill Cleaning
• Keep the outside of your grill looking new by cleaning it once a
month with warm soap and water or a non-abrasive cleaner. If
you don't have a grill cover, wipe off dust and grime before
starting your grill.
• Coating the cooking grids with spray-on cooking oil will keep the
food from sticking and make clean up easier.After cooking,
scrape the grates with a long handled, brass wire bristle brush.
• Check inside the grill bottom for grease build up and clean
often, especially after cooking fatty meat.
• Do not mistake brown or black accumulation of grease and
smoke for paint. Apply a strong solution of detergent and water
or use a grill cleaner with scrub brush on insides of grill lid and
bottom. Rinse and allow to completely air dry. Do not apply a
caustic grill/oven cleaner to painted surfaces.
Plated wire grates: Wash grates with concentrated grill
cleaner or use soap and water solution. Dry thoroughly and
store indoors between cookouts.
Plastic parts: Wash with warm soapy water and wipe dry.
,A Do not use citrisot, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
• Porcelain grates: Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use non-abrasive scouring
powder for stubborn stains.
• Cooking surfaces: If a bristle brush is used to clean any of
the grill cooking surfaces, ensure no loose bristles remain on
cooking surfaces prior to grilling. It is not recommended to
clean cooking surfaces while grill is hot.
CAUT=ON
SPIDER ALERT!
If you notice that your grill is getting hard to light or that the
flame isn't as strong as it should be, take the time to check and
clean the burners.
CONTROL PANEL
SPIDER WEBS
INSIDE TUBE
BURNER
Insome areasof thecountry,spidersor smallinsectshavebeen
knownto create"flashback"problems.Thespidersspinwebs,build
nestsandlay eggsin thegrill'sburnertube(s)obstructingthe flow of
gas to the burner.The backed-upgas canignitein thetube behind
the controlpanel.Thisis knownas a flashbackandit can damage
your grilland evencauseinjury.
Topreventflashbacksandensuregoodperformancethe burner
assemblyshouldbe removedfrom thegrill andcleanedbeforeuse
wheneverthe grillhas beenidle for anextendedperiod.
\ J
464222009" 9
Loading ...
Loading ...
Loading ...