Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
PROBLEM
Engine Will Not Start
Using Recoil Starter
Engine Stalls or Stops
After Running
Engine Loses Power
Excessive Vibration
Cutting Grass
Improperly
Poor Grass Discharge
Oil Leaking
PROBABLE CAUSE
1. Fuel tank empty.
2. Engine needs choking or priming.
1.
2.
CORRECTIVE ACTION
3. Spark plug wire disconnected. 3.
4. Spark plugfaulty. 4.
1. Blade control is released or is not being held securely 1.
against handle.
2. Fuel tank empty. 2.
3. Engine air pre-cleaner and or air cleaner dirty. 3.
4. Spark plug defective or gap set improperly. 4.
5. Water, debris or stale fuel in fuel s_/stem. 5.
1. Engine air pre-cleaner or air cteaner dirty 1.
2. Spark plug faulty. 2.
3. Water, debris or stale fuel in fuel s_/stem. 3.
1. Damaged, out of balance or bent mower blade. 1.
2. Loose blade components. 2.
3. Loose or missing air lift/if ec]uipped/. 3.
1. cutting height too low or high. 1.
2. Engine speed too slow. 2.
3. Forward ground speed too fast. 3.
4. Terraced cut, side to side. 4.
5. Excessive deck pitch, front to rear. 5.
6. Cutting btade dull or damaged. 6.
1. Engine speed too stow. 1.
2. Grass iswet. 2.
3. Excessively worn or damaged btade. 3.
4. Build up of grass clippings and debris under deck. 4.
5. Improper btade installed on deck. 5.
6. Blade installed improperly on deck. 6.
1. Leaking engine case. 1.
2.
3.
Fill fuel tank with fresh fuel.
Choke/Prime. Check Engine Manual for
instruction.
Place spark plug wire onto spark plug.
Replace with new spark plug.
Blade control should be held securely against
handle at all times during operation of mower.
Fill with fuel to proper level.
Clean free of all debris.
Service spark plug.
Drain and clean fuel s_/stem.
Clean or replace filters.
Service spark plug.
Drain and clean fuel s_/stem.
Service mower blade.
Service and tighten loose parts.
Replace air lifts. Tighten to proper torque.
Adjust cutting height.
Contact authorized SNAPPER DeaIer.
Walk at slower pace.
Adjust height of cut with height adjust bushings.
Adjust height of cut with height adjust bushings.
Sharpen cutting edges or replace blade.
Contact authorized SNAPPER DeaIer.
Mow when grass is dry.
Service mower blade.
Clean deck.
Install proper SNAPPER blade.
Install blade properly.
Contact authorized SNAPPER dealer.
Check and tighten drain plug.
Make sure dipstick or oil filler cap is securely in
place.
13
Loading ...
Loading ...
Loading ...