Loading ...
Loading ...
Loading ...
10
Powerboost function
The Powerboost function can be used to heat large amounts of
water more quickly than the power level
Š.
Restrictions when using
As two independent hotplates: (model 1) if you want to activate
this function for hotplate 1, hotplate 2 must be turned off, and
vice versa. If not turned off, the letter
› and power level Š will
flash alternately on the hotplate display and the power level
Š
will be reset without activating the function.
As one single hotplate: (model 2) the Powerboost function can
be activated on the entire hotplate. In this case, place the pan
at the centre of the flexible zone as shown in the Flexible zone
section.
To activate
1. Select the power level Š.
2. Press the programming panel located above the @› symbol.
The function has been activated.
To turn off
Press the programming panel located above the @› symbol.
The Powerboost function has been deactivated.
Note: In certain circumstances, the Powerboost function may
turn off automatically in order to protect the electronic
components inside the hob.
Time programming function
This function may be used in two different ways:
■ to automatically switch off a hotplate.
■ as a timer.
Turning off a hotplate automatically
The zone turns off automatically once the selected time has
elapsed.
Programming the cooking time
The hob must be switched on:
1. Select the desired hotplate and power level.
2. Press the 0 symbol. The x indicator on the hotplate lights
up.
‹‹ is displayed on the time program function display. To
select another hotplate, press the
0 symbol several times
until the
x indicator for the desired hotplate lights up.
3. Within the next 10 seconds, select the desired cooking time
in the programming zone. The possible default setting is,
from left to right: 1, 2, 3, etc., up to 10 minutes.
After a few seconds, the cooking time begins to elapse.
Note: The same cooking time can be automatically
programmed for the all the hotplates. The programmed time
passes independently for each of the hotplates.
The Basic settings chapter provides information on
automatically programming the cooking time.
Automatic programming
If the previous setting from 1 to 5 is pressed in the
programming panel, the cooking time is reduced by one
minute, if it is held down the time is automatically reduced to
one minute.
If the previous setting from 6 to 10 is pressed in the
programming panel , the cooking time is increased by one
minute, if it is held down the time is automatically increased to
99 minutes.
Changing or cancelling the time
Press the
0 symbol several times until the required x
indicator lights up. Change the cooking time in the
programming panel, or set to
‹‹.
Once the time has elapsed
The hotplate switches off. An audible signal sounds and
‹‹
appears in the time program function display for 10 seconds.
The
x indicator lights up. Pressing the 0 symbol turns off the
indicators and stops the signal.
Notes
■ If a cooking time has been programmed in several zones, it
can be set to display all time values. To do this, press the
0
symbol several times until the
x indicator for the required
hotplate lights up.
■ Cooking times of up to 99 minutes can be programmed.
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
Programming
1. Press the 0 symbol several times until the W indicator lights
up.
‹‹ lights up in the time program function display.
2. Select the desired time in the programming panel.
The timer starts to count down after a few seconds.
0
RGH
O
0RGHO
Loading ...
Loading ...
Loading ...