Loading ...
Loading ...
Loading ...
Aboutthe temperaturecontrols, www.GEAppliances.com
The temperature controls are preset in the factory at 37°F for the
refrigerator compartment and O°Ffor the freezer compartment.
Allow24 hours for the temperature to stabilize to the preset
recommended settings.
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET
temperature based on usage and operating environment.
Setting either or both controls to OFFstops cooling in both the
freezer and refrigerator compartments, but does not shut off
electrical power to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering
the temperature controls. If this film was not removed during
installation, remove it now.
Tochange the temperature, press and release the
WARMER or COLDERpad. Tile SETlight will come
on and tile display will show tile set temi)eramre.
To change the temperature, tap either the
WARMER or COLDERpad until tile desired
telni)erature is displayed. Refl_gei'ator telni)eratures
can be a(!justed between 34°F and 44°F and tile
fl'eezer teinperatures can be ac!justed between
-6°F and +6°E
Once the desired temperature has been set,
the temperature display will return to the actual
refl_gerator and fl'eezer teinperatures after 5
seconds. Several ac!jusnnents may be required.
Each fiine yotl a(!]/lSt controls, allow 24 ho/llN tk)i"tile
refl_gerator to reach tile temperatm'e you have set.
Toturn the cooling system off, tap tile WARMER pad
fin" either tile refl_gerator or tile fl'eezer tmtil tile
display sho_vs OFF To turn the unit back on, press tile
COLDERpad fin" either tile refrigerator or fl'eezex:
The SETlight will illuminate on the side w)u
selected. Then press the COLDERpad again (on the
side where the S_"Tlight is illuminated) and it will
go to the preset points ot O°Ftor the fl'eezer and
37°Ftor the reti_igeratox: Setting either or both
controls to OFFstops cooling in both the fl'eezer
and refl_gerator compartments, but does not shut
off' electrical power to tile refl_gerato_:
Locking the Controls (on some models)
This feature allo_vs you to lock tile controls
so the settings cmmot be changed.
Tolock the controls:
0 Set tile controls to tile desired settings.
Press and hold tile lock pad fi)r
3 seconds.
When tile controls are locked, tile indicator
light will come on and tile control settings
will not be displayed.
To unlock the controls:
Press and hold tile lock pad fin" 3 seconds.
Mter unlocking tile controls, tile settings
will be displayed, tile lock indicator light
will go out and tile settings can be changed.
Loading ...
Loading ...
Loading ...