Loading ...
Loading ...
Loading ...
12
5. Pull to remove the film off the double
sided sticky tape on the inner side of
the lower duct divider. (Fig. 6)
Film
Fig. 6
6. Stick the upper duct divider into the
assembled mounting frame.
NOTE: Make sure the upper duct
divider is compressing the top foam
on the base of the unit, and compress
to doubled sided tape on the lower
duct divider to ensure a positive
retention. (Fig. 7)
Upper Duct
Divider
Fig. 7
7. Peel to remove the release paper from
the PE foam, overlap the sticky side
over all gaps and compress to seal
and insulate the entire section. (Fig. 8)
PE Foam
Fig. 8
8. Use self adhesive foil tape to seal
all remaining gaps around the duct
divider, PE foam and roof opening,
completely sealing duct edges as
required.
9. Remove the cable compartment
cover using a Phillips screw driver.
(Fig. 9)
Fig. 9
DANGER
Electrical Shock Hazard
● Disconnect power before servicing.
Failure to obey this warning could
result in death or serious injury.
● Provide grounding in compliance
with all applicable electrical codes.
Failure to obey this warning could
result in death or serious injury.
Loading ...
Loading ...
Loading ...