Loading ...
Loading ...
Loading ...
CONTROL PURPOSE COMMENTS
Cancel
DRAIN
To reset any cycle or
options during
selection.
To cancel a wash
cycle after it's
started.
Press and hold CANCEL/DRAIN to reset any control selections made.
See "Canceling A Cycle" and "Changing A Cycle After Dishwasher Is Started" sections.
Hi,Tern p To turn the audible Press and h01dthe Hi:Temp Scrub button for 3 seconds to turn the audible tones on or off,
Wash tones on or off. Only audible tones for confirming button presses can De turned on/off, Important audible
tones, such as indicating a cycle has been interrupted, cannot be deactivated.
SoundOn/Off
Hold 3 Sec
F'% _ _ /
CONTROL PURPOSE COMMENTS
The Cycle Status Indicator Clean indicator glows when a cycle is finished.
wo,_o_o,y,_c,o__o,,_od L ghts are used to fo ow the
, i ;..... ' Ifyou select the sani Rinse option; when the sani Rinse cycle is finished,
,,,o,. i progress of ,no alsnwasner
r . , _ , :. _, the Sanitized indicator g!ows, lf your dishwasher did not proper!y sanitize
cyc e Loca[ea on iRe TROD[
of t'e dishwasJer for f t your dishes, the light f ashes at the end of the cycle. This can happen if the
n n ron
.................... "..... . . cycle is interrupted, or the water could not be heated to the required
control moae!s ana iocatea tem_er^ture
or on the top of the door for P
2............................ hidden control models. The Clean and Sanitized lights go off when you open and close the door or
,. press and hold CANCEL
A
The Front Indicator Light or
Single Exterior Light (A)
shows progress of your
dishwasher cycle by color
(for hidden control models
only).
The Cycle Status Display is
The light will be blue if the dishwasher is washing or rinsing. The light will
be red when the dishwasher is drying. The light will be white to indicate
that the cycle is complete. If the Front Indicator Light is blinking, see
"Troubleshooting" section.
The indicators Wi!l inform you if you are able to add a dish to the cYCle after
used to follow the progress it has started. It will a!so inform you if the dishwasher is washing, rinsing,
of the dishwasher cycle and drying complete and!or sanitized. They will show whether the control is
to show other informationl locked and/or the delay 0ption is se!ected. A series of bars wi!! count down
(Availab e on some mode!s the duration of the cycle remaining from left to right. Each bar equals
instead of Cycle Status approximately 24 minutes of cycle lengthl The bars will als0 count down
Indicat0r Lights)the delay feature from left to right, and the delay indicator will Deactivated,
After eve_ 30 cYcles, the dishwasher Wi!ldisplay"- "affresh; providing a
temp, orary reminder for, you to perform a monthly maintenance Pr0Cedure.
, See Dishwasher Care section:
Canceling a Cycle
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop before completely opening the door.
2. Press and hold Cancel/Drain button once. The Cancel/Drain
light will light up.
3. Close the door and the dishwasher starts a drain cycle (if water
remains in bottom of dishwasher). Let the dishwasher drain
completely. The Cancel/Drain light turns off after 2 minutes.
Changing a Cycle After Dishwasher Is Started
1. You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure.
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3. Check that detergent dispenser cover is still closed. If cover is
open, you will need to refill the detergent dispenser before
restarting your new cycle.
4. Press and hold CANCEL!DRAIN twice to reset the control.
5. Select new cycles and options.
6. Press START/RESUME.
Adding a Dish After Dishwasher Is Started
1. Check if Add a Dish indicator is lit. (Available on some models.
Otherwise, proceed to Step 2.)
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, and then open the door completely.
3. Check whether the detergent dispenser cover is still closed. If
it is open, the wash cycle has already started and adding a
dish is not recommended.
4. If detergent has not yet been used (detergent dispenser cover
is closed), you may add a dish.
5. Press START/RESUME.
11
Loading ...
Loading ...
Loading ...