Loading ...
Loading ...
Loading ...
Problem Cause
Engine fails to start. 1. Fuel tank empty, or stale fuel. 1.
2. Blocked fuel line. 2.
3. Choke not in ON position 3.
4. Faulty spark plug. 4
5. Safety key not in ignition switch on engine 5.
6. Spark plug wire disconnected. 6
7. Primer button nat being used properly. 7
Engine runs erratic. 1. Unit running on CHOKE. 1
2. Blocked fuel line or stale fuel. 2.
3. Water or dirt in fuel system 3.
4. Carburetor out of adjustment. 4
Loss of power 1. Spark plug wire loose. 1
2. Gas cap vent hole plugged. 2.
3. Exhaust part plugged. 3.
Engine overheats. 1. Carburetor not adjusted properly. 1.
Excessive vibration. 1. Loose parts or damaged auger. 1.
Unit fails 1. Traction control cable in need of adjustment. 1.
to propel itself.
2. Drive belt loose or damaged. 2.
Unit fails 1. Discharge chute clogged. 1.
to discharge snow.
2. Foreign object lodged in auger.
3. Auger control cable in need of adjustment.
2.
3.
NOTE: For repairs beyond the minor adjustments listed above,
service center.
Remedy
Fill tank with fresh gasoline
Clean the fuel line
Move switch to ON position
Clean, adjust gap or replace.
Insert the key fully into the switch.
Connect spark plug wire.
Refer to the engine manual.
Move choke lever to OFF position.
Clean fuel line and fill tank with clean, fresh
gasoline.
Drain fuel tank and carburetor. Refill with
fresh fuel.
Refer to the engine manual.
Connect and tighten spark plug wire.
Remove ice and snow from gas cap. Be
certain vent hole is clear.
Refer to the engine manual.
Refer to the engine manual or have the
carburetor adjusted by an authorized
engine service dealer.
Stop engine immediately and disconnect
spark plug wire. Tighten all bolts and nuts. If
vibration continues, have unit serviced by
an authorized service dealer.
Adjust traction control cable. Refer to
Adjustments.
Replace drive belt.
Stop engine immediately and disconnect
spark plug wire. Clean discharge chute and
inside of auger housing.
Stop engine immediately and disconnect
spark plug wire. Remove object from auger.
Refer to Final Adjustments in Assembly
Section.
4. Auger belt loose or damaged. 4 Refer to Adjustments.
5. Shear bolt(s) sheared. 5. Replace shear bolt(s).
please contact your nearest SEARS
26
Loading ...
Loading ...
Loading ...