Loading ...
Loading ...
Loading ...
8
To remove door from hinges:
To replace door on hinges:
See Figure below:
Water Supply Connections
The water supply should be ready at the point of installation. The water supply pressure should be a
minimum of 15 psi with a static pressure not more than 80 psi. (A wall outlet directly behind the ice
maker will make installation easier.)
IMPORTANT:
1. All installations must be in accordance with local plumbing code requirements.
2. Make certain that the pipes are not pinched or kinked or damaged during installation.
3. Check for leaks after connection.
Tools required: ½ in. open-end wrench, Phillips screwdriver
Connecting the water line:
1. Turn off main water supply. Turn on nearest faucet long enough to clear line of water.
2. Find a ½ in. to ¾ in. vertical cold water pipe near the installation location. The distance should be less
than 9 feet. The water supply hose provided with the ice maker is about 9 feet long.
3. A shut-off valve must be installed to the main water supply. If the water pipe has a plain piece of
copper tubing, attach a ¼” O.D. compression union to the tubing and remove the nut.
1. Using a flathead screwdriver, separate the hinge axis from hinge 1.
2. Open the door about 20°. Lift the door off the bottom hinge 2 and set the door aside.
1. Using a flathead screwdriver, remove the plug buttons from the screw holes opposite the door
hinges, top and bottom.
2. Replace the hinge axis on door hinge 1 and tighten it firmly. Remove door hinge 1 and place it on
the opposite bottom side.
3. Remove door hinge 2, place on the opposite top side. Separate the axis from hinge 2 and set it
aside.
4. Keep the handle apart from the hinge side. Align the door on the bottom hinge 1 and replace axis
on the hinge 2. Tighten it firmly.
5. Push the plug buttons into the original screw holes.
Loading ...
Loading ...
Loading ...