Loading ...
Loading ...
Loading ...
Operation of electronic models (model GSD4000 Only)
Using the Dishwasher Door
The door must be closed and locked into place to selecta LOADSELECTIONor an OPTION.
_:i Ifthe door isopenedduring a cycleand leftopen,thedishwasherwillbeeponceevery50 secondsuntilthe
.......doorisclosedand latched into place.
Start
Close and latch the door.Touch the START/RESETpad to begin the cycle. Water fill begins and
approximately 60 seconds later the wash action begins.
NOTE:The dishwasher remembers your lost cycle so you don't hove to reprogram each time. When
the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON
and display the lost settings you selected.
If you don't wont to change any of the settings, simply touch the START/RESETpod to begin
the cycle.
Also, if a power failure occurs, NORMALand HEATEDDRYwill automatically be programmed.
Make any new selections and touch the START/RESETpad to begin the cycle.
Clean
This light isilluminated when a wash cycle iscomplete. The light will stay ON until the door isopened.
Flashing Display Lights
Lights What It Means
Th snormal
TheSTART/RESETpad
hasbeen pressed.
CLEAN
What To Do
Allow the dishwasher to drain and reset before you start a new
wash cycle.
Control Error
Pressthe START/RESETpod to turn off the beeper.If the CLEAN
light continues to flash,call for service.
PLUS A
BEEPING
SOUND
_ASH
PLUS A
BEEPING
SOUND
Control Error
Pressthe START/RESETpod to turn off the beeper and the
dishwasher will attempt to reset. Restartthe wash cycle.
Ifthis error continues,turn off the power to the dishwasher at
the circuit breakerfor 30 seconds.Try the dishwasher again.
Ifthe error isstill present,call for service.
10
Loading ...
Loading ...
Loading ...