Craftsman 917377391 rotary lawn mower

User Manual - Page 14

For 917377391.

PDF File Manual, 30 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Before performing any
service or adjustments:
1. Release control bar and stop engine.
2. Make sure the blade and all moving
parts have completely stopped.
3. Disconnect spark plug wire from spark
plug and place where it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST cu'n'ING HEIGHT
See "TO ADJUST CU'I-RNG HEIGHT" in
the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibility that obiects will
be thrown out of the rear of the mower
intothe operator mowing position, tf the
deflector becomes damaged, it should be
replaced.
TO REMOVE/REPLACE DRIVE BELT
1. Remove drive cover. Remove belt
from gearcase pulley by pushing
down on pulley and rolling belt off it.
2. Turn lawn mower on its side with air
filter and carburetor up.
3. Remove blade.
4. Remove debds shield.
5. Remove belt from engine pulley on
crankshaft.
6. Install new belt by reversing above
steps.
7. Always use factory approved belt to
assure fit and long life.
Drive
Bert
Push
down
TO ADJUST HANDLE
The upper handle may be adjusted to
four (4) different height positions,
1, Loosen both handle knobs only
enough to allow the upper handle to
pivot to the desired adjustment
position..
2. Tighten both handle knobs securely,
Handle Knob
Handle Knob
TO ASSEMBLE GRASS CATCHER
1,Put grass catcher frame into grass bag
with dgid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top,
2. Slip vinyl bindings over frame.
NOTE: Ifvinyl bindings are too stiff, hold
them in warm water for a few minutes, If
bag gets wet, let it dry before using.
_CAUTION: Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear
door removed or propped open,
Catcher
frame
handle
\ ,
_t Frame
opening
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that the engine is running too fast
or too slow, take your lawn mower to a
Sears or other qualified service center for
repair and adjustment.
14
Loading ...
Loading ...
Loading ...