D-Link DIS-3650AP User Manual

Loading ...

Web User Interface

Transmit Power:

WMM (Wi-Fi

Multimedia):

Ack Time Out

(2.4 GHZ, 64~200):

Short GI:

IGMP Snooping:

Multicast Rate:

Multicast Bandwidth

Control :

Maximum Multicast

Bandwidth :

HT20/40 Coexistence :

Transfer DHCP Oer

to Unicast :

PMF:

This setting determines the power level of the wireless transmission. Transmitting power can be adjusted to eliminate the

overlapping of wireless area coverage between two access points where interference is a major concern. For example, if wireless

coverage is intended for half of the area, then select 50% as the option. Use the drop-down menu to select 100%, 50%, 25%, or

12.5%.

WMM stands for Wi-Fi Multimedia. Enabling this feature will improve the user experience for audio and video applications over

a Wi-Fi network.

To eectively optimize throughput over long distance links enter a value for Acknowledgement Time Out between 25 and 200

microseconds for 5 GHz or from 64 to 200 microseconds in the 2.4 GHz in the eld provided.

Select Enable or Disable. Enabling a short guard interval can increase throughput. However, be aware that it can also increase

the error rate in some installations due to increased sensitivity to radio-frequency installations.

Select Enable or Disable. Internet Group Management Protocol allows the AP to recognize IGMP queries and reports sent between

routers and an IGMP host (wireless STA). When IGMP snooping is enabled, the AP will forward multicast packets to an IGMP host

based on IGMP messages passing through the AP.

Adjust the multicast packet data rate here. The multicast rate is supported in AP mode, (2.4 GHZ and 5 GHZ) and WDS with AP

mode, including Multi-SSIDs.

Adjust the multicast packet data rate here. The multicast rate is supported in AP mode, and WDS with AP mode, including Multi-

SSIDs

Set the multicast packets maximum bandwidth pass through rate from the Ethernet interface to the Access Point.

Enable this option to reduce interference from other wireless networks in your area. If the channel width is operating at 40MHz

and there is another wireless network’s channel over-lapping and causing interference, the Access Point will automatically change

to 20MHz.

Enable to transfer the DHCP Oer to Unicast from LAN to WLAN, suggest to enable this function if stations number is larger than 30.

Enable this option to help protect clients against forged management frames spoofed from other devices that might otherwise

disrupt a valid user session.

Loading ...

D-Link DIS-3650AP Outdoor Industrial AC1200 Access Point