Loading ...
Loading ...
Diagram of water circulation for one set fountain with two
pieces, by the perpendicularity links up.
PUMP ASSEMBLY INSTRUCTIONS:
1. Remove the pump from the package and untie the power
cord. Adjust the flow rate (if applicable) to the maximum (+)
position.
2. Drag out one end PVC tube from the bottom of Fountain
Upright (as shown in Fig.①.) to connect with the pump. Place
the pump in a suited location in the Fountain Cistern, and
assembled the Fountain Upright on the Fountain Cistern at
the same time (as what picture shows). Make sure they fitted
well.
3. Add water according to what picture shows. Make sure that
water level does not exceed the front and back rock bottom.
4. Connect the power cord from the pump to a properly
grounded, grounding type receptacle (GFCI). Processing
circuit.
Diagram of water circulation for twist and lock style
fountain.
PUMP ASSEMBLY INSTRUCTIONS:
1. Remove the pump from the package and untie the power
cord. Adjust the flow rate (if applicable) to the maximum (+)
position. Pass the power cord through the middle of the Basin
and Pedestal, drag the power cord out from the hole of
Pedestal bottom (as what picture shows).
2. Tighten the screws to assemble the Basin and the Pedestal
(as shown in Fig.① & Fig.②).
3. Drag out one end PVC tube from the bottom of the Fountain
Upper-end to connect with the pump. Place the pump in a
suited location in the Basin(as shown in Fig.②.).
4. Tighten the screws to assemble the Fountain Upper-end
and the Basin (as shown in Fig.②. & Fig.③.).
5. Add water according to what picture shows. Make sure that
water level cover the pump fitly just completely.
Loading ...
Loading ...
Loading ...