Loading ...
Loading ...
Loading ...
31
Changing the Filter
Locating the Filters
Your refrigerator is equipped with water
ltering system. The water lter system lters
the water used to produce ice.
Water Filter
The water lter is located at the top right
side of the fresh food compartment.
Ordering Replacement Filters
To order your replacement lters, please
visit the dealer where you purchased your
refrigerator. Sears recommends that you
order extra lters when you rst install your
refrigerator, and that you replace your lters
at least once every six months.
Here is the product number to request
when ordering:
Kenmorepure!
TM
Water Filter
Part #046-9999
Replacing the Water Filter
In general, you should change the water
lter every six months to ensure the highest
possible water quality. Water Filter Status
on the user interface prompts you to replace
the lter after a standard amount of water
(200 gallons/757 liters for Kenmorepure!
TM
)
has owed through the system.
If your refrigerator has not been used
for a period of time (during moving
for example), change the lter before
reinstalling the refrigerator.
Filter Cartridge
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
or after the system. Systems certied for
cyst reduction may be used on disinfected
waters that may contain lterable cysts.
Test & Certication Results:
• Rated Capacity - 200 gallons/757 liters
for Kenmorepure!
TM
ice and water lter
• Rated service ow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds
per square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To Replace your Kenmorepure!
TM
Water Filter:
It is not necessary to turn the water supply
o to change the lter. Be ready to wipe up
any small amounts of water released during
the lter replacement.
1. Turn O ice maker.
2. Remove the lter by pushing on the end/
face of the lter.
3. Slide the old water lter cartridge straight
out of the housing and discard it.
4. Unpackage the new lter cartridge. Using
the alignment guide, slide it gently into the
lter housing until it stops against the snap-
in connector at the back of the housing.
5. Push rmly until the cartridge snaps into
place (you should hear a click as the
cartridge engages the snap-in connector).
6. Turn On ice maker.
7. To reset the water lter on your IQ-Touch
control, press and hold the water lter
icon for three seconds. When the display
changes from Red to Green, the status
has been reset.
The Kenmorepure!
TM
ice and water
lter system is tested and certied to
NSF/ANSI Standards 42 and 53 for
the reduction of claims specied on
the performance data sheet.
More about your Advanced Water Filter
NOTE
When ordering your replacement lter,
please reorder the same lter type that is
currently in your refrigerator.
Loading ...
Loading ...
Loading ...