Loading ...
Loading ...
Loading ...
CLEANING AND MAINTENANCE - 5391477A150/B
e
that uses heat to remove light grease residues. It
does not remove sugar-based residues.
1. First clean the base and the top of the oven
cavity using a microfibre cloth soaked in
water and neutral washing up liquid. Rinse
thoroughly.
2. Set a regeneration cycle by selecting a fan
assisted function at the maximum
temperature for one hour.
3. If the self-cleaning panels are particularly
dirty after the regeneration cycle, remove
them and wash them with neutral washing
up liquid. Rinse and dry them.
Put the self-cleaning panels back in the oven
and use a fan assisted function at 180°C for an
hour to ensure that they are thoroughly dry.
Removing self-cleaning panels and rack/tray
support frames (on some models only)
Removing the side self-cleaning panels and the
rack/tray support frames enables the sides to
be cleaned more easily. This should be done
each time the automatic cleaning cycle is used
(on some models only).
To remove the rack/tray support frames:
• Pull the frame towards the inside of the oven
cavity to release it from its groove A. Then
slide it out of the seats at the back B. The
side self-cleaning panel is attached to the
rack/tray support frame.
• After cleaning, repeat the above procedure
to put the self-cleaning side panels and
rack/tray support frames back.
Vapor Clean (on some models only)
Preliminary operations
Before starting the Vapor Clea n cycle:
• Completely remove all accessories from
inside the oven.
• Remove the temperature probe, if present.
• Remove the self-cleaning panels, if present.
• Pour approx. 120 cc of water onto the floor
of the oven. Make sure it does not overflow
out of the cavity.
• Spray a water and washing up liquid
solution inside the oven using a spray
nozzle. Direct the spray towards the side
walls, upwards, downwards and towards
the deflector.
• Close the door.
• During the assisted cleaning cycle, wash the
self-cleaning panels (where fitted), which
were previously removed, separately in
warm water and a small amount of
detergent.
Vapor Clean cycle setting
1. Turn the functions knob to symbol or
(where present).
2. Turn the temperature knob to the
symbol.
3. Allow the cleaning cycle to run for 18
minutes.
Vapor Clean End
1. Turn the function knob to 0 to exit from the
function.
2. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
We recommend carrying out the self-
cleaning panel regeneration cycle
every 15 days.
During the removal take care not to
detach the self-cleaning panel from the
rack/tray support frame accidentally to
avoid damaging the surfaces.
See General safety instructions.
The Vapor Clean function is an assisted
cleaning procedure that facilitates the
removal of dirt. Thanks to this process, it
is possible to clean the inside of the
oven very easily. The dirt residues are
softened by the heat and water vapour
for easier removal afterwards.
We recommend spraying approx. 20
times at the most.
Do not spray the deflector if it has a self-
cleaning coating.
Loading ...
Loading ...
Loading ...