Loading ...
Loading ...
Loading ...
BEFORE EACH USE
• Checkwaterinletscreenfordamage.
• Check
• Check
o
high pressure hose for leaks.
detergent inlet hose and filterfor damage.
Check gun and wand assembly for leaks.
Purge pump of air and contaminants.
Check engine oil level.
PRESSURE WASHER MAINTENANCE
Gheck and Clean Inlet Screen: Remove quick-connect
and examine inlet screen on the female connector.
Clean if it isclogged or replace ifit istorn.
Check High Pressure Hose: High pressurehose can
develop leaks from wear, kinking,abuse, inspecthose
each time beforeusingit. Checkfor cuts, leaks, abra-
sionsor bulgingofcover, or damage or movementof
couplings.If any ofthese conditionsexist, replacehose
immediately.
=t
DANGER: Water spraying from a leak is
capable of Injecting material into skin.
NEVER repair high pressure hose. Replace
with hose that meets minimum pressure rat-
ing of your pressure washer.
ENGINE MAINTENANCE
CAUTION: Disconnect spark plug wire from
spark plug and keepwire away from spark
plug.
CHECKING OIL LEVEL
Oil levelshouldbe checked priorto each use or at least
every 5 hoursof operation.Keep oil level maintained.
CHANGING ENGINE OIL
Change oilafterfirst 8 hoursof operation.Change oil
every50 hoursthereafter. Ifyou are using your pressure
washer under extremelydirtyor dusty conditions,or in
extremely hot weather, change oil more often.
Change oilwhile engine is stillwarm from running,as
follows:
• Beforeyou tip the pressurewasher to drain oil, drain
fuel tank by runningpressurewasher until fuel tank is
empty.
• Clean area aroundoilfill, removeoil fillcap/dipstick.
Wipe dipstickclean.
Tip yourpressurewasher as shownto drain oil com-
pleletyintoa suitable container.When crankcase is
empty, returnthe pressurewasher to itsuprightposi-
tion.
Check Detergent Hose: Examine the filteron the deter-
gent hose and clean if clogged. Hose shouldfittightlyon
barbed fitting.Examine hosefor leaks ortears. Replace
the filter or hose ifeither isdamaged.
Check Gun and Wand: Examine hose connectionto
gun and make sure itis secure.Test triggerby pressing
itand makingsure itspringsback intoplace when you
release it. Put safety latch in ON positionand test trig-
ger. You shouldnot be able to press trigger.
Purge Pump of Air and Contaminants
To remove the air from the pump, followthese steps:
• Set up the pressure washer as described in the
ASSEMBLY sectionand connect the water supply.
Remove the wand extension from the gun.
Pullthe triggeron the gun and hold.
To remove the contaminantsfrom the pump, follow
these steps:
• Set up the pressure washer as described in the
ASSEMBLY section, and connect the water supply.
• Remove the nozzle attachment from the gun.
• Startthe engine accordingto instructionsin OPERA-
TION section.
Pullthe trigger on the gun and hold.
When the water supplyis steady and constant,
engage the safety latch and refastenthe nozzle
attachment.
Fillengine crankcase with recommended oil untiloil
level is at FULL point on dipstick. Do not overfill
above that mark. About 20 ounces is required. POUR
SLOWLY.
,=p
When engine crankcase isfilled to proper level,
installand tighten oilcap/dipstick.
Loading ...
Loading ...
Loading ...