Loading ...
Loading ...
Loading ...
49-5000633 Rev. 0 5
USING THE AIR CONDITIONER
Controls
This section explains how to operate this air conditioner.
IMPORTANT:
When you turn off the air conditioner, either at the control
panel or with the remote control, wait at least 3 minutes
before turning it back on. This prevents the compressor
from overloading. This 3 minute delay also applies when
switching from cool mode to fan and back.
NOTE: There is a built in 3 minute delay. You may
notice the compressor might not start right away. This
was designated to protect the unit.
Do not operate your air conditioner in the Cool Mode
when the outside temperature is below 61° F (16° C).
This inside evaporator coil will freeze up, and the air
conditioner will not operate properly.
NOTE: When the air conditioner is first plugged in,
the LED display will show “88” for 3 seconds. After
the air conditioner is turned on for the first time, the
display will show the temperature 72° F and the fan will
automatically set the Quiet speed and the Mode indicator
will show ENERGY SAVE.
NOTE: To switch the temperature display between
Fahrenheit (°F) and Celsius (°C), the air conditioner
must be plugged in and turned on. On the control panel
RQWKHIURQWRIWKHDLUFRQGLWLRQHUSUHVVWKH83DQG
DOWN button at the same time and hold for 3 seconds.
Press F/C button on remote control to switch between
Fahrenheit (°F) and Celsius (°C).
NOTE: Each time this ENERGY STAR qualified air
conditioner is turned on, it will operate in energy save
mode per the EPA requirements. You can select any
other mode to satisfy your needs.
Features and appearance will vary.
Controls
1. MODE
1. Press MODE until you see the indicator light come
on next to the desired setting.
2. Choose Fan, Cool, Energy Save, or Dehum.
Fan - Only the fan runs. Press SPEED to select
High, Med or Quiet fan speed. The display shows the
current room temperature. NOTE: in fan mode, the
temperature cannot be set.
Energy Save - In this this mode the fan runs only
when cooling is needed. The fan will run for 3
minutes after the compressor shuts off. The fan then
cycles on for 2 minutes at 10 minute intervals until the
temperature in the room is above the set temperature.
The compressor then turns back on.
Cool - Cools the room. Press SPEED to select High,
Med, Quiet or Auto Cool fan speed. Press the TEMP/
TIME + or – arrow button to adjust the temperature.
The fan will run continuously in cool mode.
Dehum - Aids in removing humidity from the room.
Dehum mode cannot be used to cool room.
NOTE: In Dehum mode, when the set temperature
is close to ambient temperature, the compressor may
stop and the fan will run in Quiet speed only.
2. SPEED
1. Press SPEED until you see the indicator light come
on next to the desired setting.
2. Choose High, Med, Quiet, or Auto Cool
HIGH - For maximum cooling.
MED - For normal cooling.
QUIET - For minimum cooling and noise.
AUTO COOL - Adjusts the fan speed automatically to
provide ideal cooling based on the room temperature.
Loading ...
Loading ...
Loading ...