User Manual SOLVTIN S6 Jump Starter 1200A Car Starter for up to 7.5L Gas and 6.0L Diesel Engine 12V Battery Jump Starter with Smart Jumper Cables Portable Power Bank with PD18W Port, QC 3.0 and LED Light

Documents for SOLVTIN S6

The following documents are available:
User Manual Photos
S6 photo
55.5Wh
400A
1200A
IP65
This device is equipped with smart energy saving system. It will shut down automatically
once there is no load.
If the following solution can not solve the problems, please do not use the device again
and contact the seller or manufacturer.
The device can not
turn on when you
press the power
switch.
Do not use it as a car battery.
Do not use it as a car battery charger.
Do not use the device to start the car when it is being charged.
1. Low voltage protection
activated.
2. Over-heating protection
activated.
1. Recharge the device until the
power is above 75%.
2. Let the device cool down for
10 minutes until the temperature
is below 55 before the next use.
5V/2.4A,
Green LightSketch
The connection is correct and the
device is ready to start your car.
The device is too hot, please let
the device cool down. /The power
of the device is to low to start the
car./ Please connect the jumper
cables with the device tightly.
Red Light
ON OFF
OFF ON
Blinking OFF
OFF OFF
Reason/Solutions
The power of the car battery
is too low or the car battery is
totally dead. Press "BOOST"
button, the green light will turn
on then start the engine in 30
seconds.
OFF Blinking
Blinking Blinking
Overcurrent protection, please
wait at least 30 seconds until
the next try.
Overheating protection, please
wait 10 minutes until it cool
down.
The connection between the
battery and clamps is reserved.
Please reconnect it correctly
until the green indicator light on.
Red light on with
Buzzing
Model No.: S6
PD18W
S6
PD 18W
PD 18W
S6
S6
S6
S6
S6
S6
S6
Thank you for choosing SOLVTIN S6 Smart Jump Starter.
Power Switch
Power
Press the power switch, the indicator will show the remaining power as follows:
Operate following the status of the smart indicator on the
jumper cables.
Go back to your car and start the engine.
The indicator will blink when the device is being charged. The four lights will stay on
when the device is fully charged.
USB Output (5V/2.4A)
USB Output (5V/9V/12V QC 3.0)
157铜板折页,单黑正反印刷,90*120mm
Made in China
Discharge Temp. -20 ~ 60(-4~140)
Charge Temp. 5~ 45(41~113)
Loading ...
Loading ...
Loading ...

Specifications

SOLVTIN S6 Questions and Answers

Find answers or Ask a question.


  • Total questions: 2
  • Questions unAnswered : 1

Q: I Bought a solvtin 6.It did start the car with ease,but when I tried to charge it,the charging terminal the terminal broke off. Now I have a battery that I can't recharge?Any solution? Reply

See other models: S6 PRO