Loading ...
Loading ...
Loading ...
To select a pile height setting:
Turn off vacuum cleaner. Select a pile
height setting by tilting the cleaner back
until the front wheels are lifted slightly off
the floor.
Slide the adjustment lever to the correct
setting.
There are four (4) pile height settings on
the vacuum cleaner. Use the LOW setting
for most low-pile carpets and bare floor
cleaning. Use the HIGH setting for high-
pile carpets like shag carpet, scatter rugs,
etc. Use the other settings as needed for
carpet heights in between.
CAUTION
Do not allow vacuum cleaner to remain
in one spot for any length of time
when the agitator is turning. Damage
to carpet may occur.
Bare floor setting: Slide the carpet/bare
floor selector all the way back and down
toward the bottom of the nozzle until it locks
into place.
in this position the brush assembly does not
revolve. This setting should be used for
cleaning hardwood and tile floors and when
any attachments (tools) are used.
Carpet setting: Slide the selector all the
way forward and up to the carpet
position.
in this position the brush assembly will turn.
When carpets are being cleaned the selec-
tor should be in this position.
Attention: Refer to your carpet manufac-
turers cleaning recommendations. Some
more delicate carpets may require that they
be vacuumed with the agitator turned off, to
prevent carpet damage.
IbCAUTION
Do not allow vacuum cleaner to remain
in one spot for any length of time
when the agitator is turning, Damage
to carpet may occur.
Note: For longer belt life, turn vacuum
cleaner off before moving selector. Failure
to do so can cause the belt to rub on the
selector shaft and may result in the belt
becoming hot and creating a burning rubber
smell.
To Bare FlOor
Position I
Floor Selector
Loading ...
Loading ...
Loading ...