Loading ...
Loading ...
Loading ...
21
Specks of grease can gather on the surface of the stainless steel and get baked-on. These can be removed by
using a mild abrasive pad with a stainless steel cleaner. Use the mildest cleaner and always scrub in the
direction of the grain. Do not use steel wool to clean the grill.
Do not use abrasives on the polished highlights. Be extra careful when cleaning around the highlights. Metal
polisher or mild chrome cleaner can be used to bring back the luster on highlights. To touch-up minor
scratches in the stainless steel, sand the affected surface very lightly, with 100-dry grit emery sandpaper in
the direction of the grain.
GRATES
The easiest way to clean the grates is to scrub them with a barbeque
brush immediately after cooking is completed and the flame is turned
off.
Wear a barbeque mitt to protect your hands from the heat and steam.
Dip a barbeque brush in tap water and scrub the hot grill. Dip the brush
frequently in tap water. Steam, created as water comes in contact with
the hot grill, helps loosen food particles stuck in the grill. These food
particles will either get burned by the briquettes or fall into the
cleaning pan. Cleaning of the grill would be longer and more difficult
if the grill racks are allowed to cool before cleaning. When cleaning
the grates make sure not to hit the rotisserie burner.
CERAMIC BRIQUETTE TRAY
It is not necessary to remove and clean the briquettes from the tray
after every grilling. They burn themselves clean during the next
cooking operation. If desired, you can burn them clean by lighting
the grill and letting it burn on high for about 30 minutes with the
briquette tray upside down. Periodically, the briquette trays need to
be cleaned. Remove them from the grill, shake loose the debris and
wipe the trays clean. Do not handle a hot briquette tray.
CAUTION
DO NOT place briquette trays over the infrared sear zone burner. This
will block the infrared heat and will cause damage to the tray.
REPLACING THE BRIQUETTES
1) Remove the screws that hold the trim.
2) Remove the old briquettes and place the new briquettes on
the same location as the old ones.
3) Place the trim with the flash-tube-hole on the trim on the same
side as the flash-tube-hole on the tray.
4) Replace screws and tighten.
Loading ...
Loading ...
Loading ...