Loading ...
Loading ...
Loading ...
33
Troubleshooting
Built-In Advantium Oven
Questions?
Use this
problem
solver
Problem Possible Causes What To Do/Explanation
LIGHTS
Light during a
speedcook cycle dims
and cycles on and off,
even at full power levels
This is normal. Power level
has been automatically
reduced because the oven
is hot.
This is normal. The oven senses
the heat level and adjusts
automatically.
Light visible around the
door and outer case
while speedcooking
This is normal. When the oven is on, light may be
visible around the door and outer
case.
FAN
Fan continues to run
after cooking stops
The oven is cooling. The fan will automatically shut off
when the internal parts of the oven
have cooled.
Oven vent emits warm
air while oven is on
This is normal.
Fan comes on
automatically when
using the microwave
This is normal.
COOKING
The oven makes unusual
sounds while cooking
Clicks and fans blowing are
normal. The relay board is
turning the components on
and off.
These sounds are normal.
Smoke comes out of the
oven when I open the
door
Food is high in fat content.
Aerosol spray used on the
pans.
Smoke is normal when cooking
high-fat foods.
Food is not fully cooked
or browned at the end of
a cooking program
Programmed times may not
match the size or amount
of food you are cooking.
Adjust time for doneness or adjust
the upper or lower lamps for
browning and doneness.
SENSOR ERROR
displayed along with an
oven signal
Food amount or type placed
in the oven does not match
the program that was set.
Press the CANCEL/OFF pad. Set
the oven program to match the food
or liquid to be cooked or heated.
Steam was not sensed by
the oven because plastic
wrap was not vented, a lid
too tight was on the dish or
a liquid was covered.
Vent plastic wrap, use a looser lid
or uncover liquids when cooking or
heating.
Loading ...
Loading ...
Loading ...