Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Machine Power cord not plugged in. Plug into a grounded 3 prong outlet.
Stops No power at plug. Check electrical source or calI
eIectrician.
Fuse blown or circuit Replacefuse or reset circuit breaker.
breaker open. If problem continues, calI eIectrician.
Using an extension cord. Do not use extension cords.
Timer is not lined up. Turn timer to the rightslightly
and pullto start.
Timer knobnot pulled out. Set and pull out knob.
Washerat pause in Allow cycle to continue (see
PERMANENT PRESS II Cycle "Washer Use").
(approximatelytwo minutes).
Machine is overloaded. Washsmaller loads.
Agitator Not The topof the agitator moves This is normal.
Working only in onedirection.
The top of the agitator is loose. This is normal.
Water Level The top of the agitator is much This is normal.
Too Low/Not higherthan the highest water
Completely level.This creates a perception
Filling of the washer not being full
Tub is Tub pulled forward when Ensuretub is centered before
Crooked unloading, starting washer.
Tub moves. This is normal.
Unit not level. Ensure front feet are installed and
nuts are tightened. Levelwasher.
Reset rear legs (see "Installation
Instructions").
Lint on Load Improper sorting. Sort lint givers from lint takers
and by color.
OverIoading. Lint can betrapped in load if
overloaded. Wash smaller loads.
Paperor tissue in pockets. CIeanout pockets beforewashing.
Not enough detergent. Use enough detergent to
hold lintin water.
Detergent not dissolving, UseAutomatic TemperatureControl
Watertemperatures lower (ATC).ATC ensureswash water
than 70°F (21°C). temperature will be warmer than
70°F (21°C).
3O
Loading ...
Loading ...
Loading ...