Loading ...
Loading ...
Loading ...
CLEANING AND MAINTENANCE
• To ensure long lasting performance of your hair clipper, clean the blades and unit
regularly.
• Always keep the hair clipper in the provided storage pouch to avoid damage to the
blades.
• Ensure the appliance is switched off and unplugged from the mains before
cleaning.
• Do not use harsh or corrosive cleaners on the unit or blades.
• Cleaning should be done with the cleaning brush provided.
• After each use - brush the accumulated hair from the blades.
WASHABLE CLEANING
• The Rapid Cut Hair Clipper is fully washable for easy cleaning, the entire clipper
may be held under running water.
WASHOUT PORT INSTRUCTIONS
• For best results, keep the clipper running while running it under the tap. Allow
water to run through the washout port and over the blades. Recommended to rinse
after each use.
• Ensure the clipper is dry after cleaning.
• For more thorough cleaning the blade set can be easily removed to wash any hair
trimmings from the blades. To release the blade set, push the removable blade
cartridge outward and away from the clipper by pushing on the thumb pad.
• Ensure the blades are dry after rinsing under the tap. To reattach, align the blade
set onto the clipper and push the blade set towards the clipper body until it clicks
into place.
• Place a small drop of cutter or sewing machine oil onto the blades at each end and
at the middle point of the blades. Turn the unit on for a few seconds to distribute
the oil then turn off and wipe off excess oil. NOTE keep the blades lubricated after
contact with water.
BEFORE CUTTING YOUR HAIR
CORDED USE:
• For corded use connect the product to the adaptor, then to the mains power outlet.
CAUTION: Extended mains only use will result in the reduction of the battery life.
• It is advisable not to use this hair clipper directly from the power outlet when it has
been fully charged, but if while using the hair clipper in cordless mode there is a
noticeable drop in power, you can use it directly from the power outlet.
6
Loading ...
Loading ...
Loading ...