Loading ...
Loading ...
Loading ...
8
TO LOCK MOTOR HEAD IN RAISED POSITION
• Push locking lever into UNLOCK position
and hold.
• Tilt motor head back.
• Move locking lever into LOCK position.
TO LOCK MOTOR HEAD IN OPERATING
POSITION
• Push locking lever into UNLOCK position
and hold.
• Lower motor head until it is completely
down into operating position.
• Move locking lever into LOCK position.
• Before mixing, test motor head lock by
attempting to raise head.
NOTE: Motor head should always be kept
in LOCK position when using mixer.
TO OPERATE CONTROL SPEED
• Speed control lever should always be set
on lowest speed for starting, then gradually
moved to desired higher speed to avoid
splashing ingredients out of bowl. See
“Speed Control Guide.”
0 1 2 4 6 8 10
6
TO ATTACH BOWL
• Be sure speed control is OFF.
• Tilt motor head back.
• Place bowl on bowl-clamping plate.
• Turn bowl gently in clockwise direction
(see picture above).
• Sit pouring shield on bowl.*
* If Pouring Shield is included
TO REMOVE BOWL
• Turn speed control to OFF.
• Tilt motor head back.
• Turn bowl in counterclockwise direction.
TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Raise motor head.
• Slip beater onto beater shaft and press
upward as far as possible.
• Turn beater to right, hooking beater
over pin on shaft.
TO REMOVE FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Raise motor head.
• Press beater upward as far as possible and
turn left.
• Pull beater from beater shaft.
Ki
t
c
hen
A
i
d
S
t.J
os
e
p
h
,
M
i
ch
i
g
a
n
,
U
S
A
0 1
2 4 6
8
10
OFF
ON
7
Motor Head
Bowl Lift Handle
(not shown)
Spring Latch and
Bowl Pin
(not shown)
Attachment
Knob
Attachment Hub
Locating Pins
Wire Whip
Flat Beater
Dough Hook
Speed Control
Lever
Bowl Support
Beater
Shaft
4.8 L (5 Qt) Stainless
Steel Bowl
Bowl Lift Mixer Features
English
W10544160C_v04.indd 8 6/1/15 3:02 PM
Loading ...
Loading ...
Loading ...