Loading ...
Loading ...
Loading ...
Problem solving guide
104
Fault in the AutoDos (automatic dispensing)
Problem Cause and remedy
The message
Insert PowerDisk or deactiv-
ate AutoDos with OK ap-
pears in the display.
The AutoDosfunction is active but no PowerDisk
has been inserted.
Insert a PowerDisk (see the “Detergent” chapter,
“Automatic dispensing/AutoDos” section).
If you do not wish to use automatic dispensing,
deactivate the function using OK or the Auto-
Dossensor control.
The warning buzzer is
sounding.
The programme does
not start or a pro-
gramme that has
already started stops.
The message
AutoDos lid open appears
in the display.
The lid has not been closed properly.
Close the AutoDos lid and lock it fully (see “Deter-
gent” chapter, “Automatic dispensing/AutoDos”
section).
If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see “Detergent”
chapter, “Inserting a PowerDisk” section).
If the same fault message appears again, call
Miele Service.
The message
PowerDisk empty. Deactiv-
ate AutoDos with OK ap-
pears in the display.
The AutoDosfunction is active and the PowerDisk
is empty.
Replace the PowerDisk (see the “Detergent”
chapter, “Automatic dispensing/AutoDos” section).
If you do not wish to use automatic dispensing,
deactivate the function using OK or the Auto-
Dossensor control.
The message
PowerDisk empty. Deactiv-
ate AutoDos with OK ap-
pears in the display
even though you have
inserted a new
PowerDisk.
The dishwasher was switched off when the
PowerDisk was replaced and it has therefore not re-
cognised the new PowerDisk.
Switch the dishwasher on before replacing the
PowerDisk (see the “Detergent” chapter, “Auto-
matic dispensing/AutoDos”, “Inserting a
PowerDisk” section).
Loading ...
Loading ...
Loading ...