Loading ...
Loading ...
Loading ...
36
Optional program settings
At the factory, temperature and spin speed options, and
cycle duration ("Finish in" time) are pre-set for all cycles.
After selection of the cycle, these values are displayed in
the display field.
EcoPerfect
Energy optimised washing by reducing the temperature
while achieving a washing result that is consistent with
the selected program, without the EcoPerfect setting.
Prewash
For heavily soiled washing. Pour 1/3 of normal detergent
amount into pre-wash chamber I and remaining 2/3 into
main wash chamber II.
Rinse Plus
This feature adds additional rinses to selected program
which is helpful for locations with soft water supplies or
to generally improve rinsing results. It will increase the
program duration.
Remote Start
Briefly pressing the Remote Start button activates or
deactivates the Remote start function. Activating the
Remote start function enables the appliance to be started
remotely via the Home Connect app.
NOTICES
▯ Remote start can only be activated if the appliance
door is closed and the appliance is connected to your
home network.
▯ Remote start will be deactivated in the following
circumstances:
▯ The door is opened.
▯ There is a power failure.
▯ The Remote Start button was briefly pressed again
deactivating it.
▯ The center of the Program Selector was pressed
switching off the appliance.
▯ Once the program has ended.
▯ A program was not started within a 24 hour period
after activating the Remote start function.
▯ Any button was pressed or the program selector
was turned on the control panel.
Pressing and holding the Remote Start button for at least
3 seconds enters Home Connect settings.
Finish in
The program end (Finished in) time can be set in one
hour increments to a maximum of 24 h (hours). After
selecting the desired washing program (at the dial) but
before pressing the Start/Pause button, press the Finish
in button until the desired time is displayed, e.g. 8 h.
Press the Start/Pause button to start the washer.
NOTICE: The cycle duration is included in the set Finish
in time.
Here is an example of a 1hr:30min cycle time and an 8 h
Finish in time.
8 h is displayed (until the Energy-saving mode activates)
and counts down (approximately 6hr:30min) until the
washing cycle begins (at 1hr:30min) then the cycle
duration 1:30 is displayed and began. Total time
approximately 8 hours.
Spin Speed
Before and during the cycle, you can change the spin
speed range depending on the cycle progress.
Touch the appropriate button until the desired setting is
displayed.
No Spin: This option eliminates the final spin and the
load remains saturated with the final rinse water. The
pump is activated to remove all residual water.
~ Program selection table; Page 34
Temperature
Before and during the cycle, you can change the default
temperature range depending on the cycle progress.
Press the appropriate button until the desired setting is
displayed.
The maximum temperature range that can be set
depends on the cycle selected.
~ Program selection table; Page 34
SpeedPerfect
For washing in a shorter time with a washing result
comparable to that of the standard program.
NOTICE: Do not exceed the maximum load.
~ Program selection table; Page 34
Stains
There are four types of stain to choose from:
The washer adjusts the average washing temperature,
drum movement and soaking time to the specific type of
stain. Hot or cold water, gentle or intensive washing and
long or short soaking ensure that the wash-program
sequence is specially adapted to each type of stain. This
makes sure that stains are treated in the best possible
way.
NOTICE: Pressing and holding the button automatically
runs through the set values.
Ê
Oils, food based
¶
Blood
º
Red wine
·
Grass
Loading ...
Loading ...
Loading ...