Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
PROBLEM
Engine Will
Not Start
Engine Hard
To Start
Engine Will
Not Turn Over
Engine Clicks
but Will Not
Start
Unit Does not
Travel in a
straight line
Excessive
Vibration
1,
2.
3.
4,
5.
6.
7.
8.
9.
10.
11.
12.
1,
2.
3.
4.
5.
6.
7.
8.
1,
2.
CAUSE
Out of fuel
Engine not "choked" properly
Engine flooded
Bad spark plug
Dirty air filter
Dirty fuel filter
Water in fuel
Loose or damaged wiring
Carburetor out of adjustment
Engine valves out of adjustment
Extreme cold conditions
Fuel shut off valves closed
Bad spark plug
Dirty air filter
Dirty fuel filter
Weak or dead battery
Carburetor out of adjustment
Engine valves out of adjustment
Loose or damaged wiring
Stale or dirty fuel
Directional handles not in correct position
PTO engaged
CORRECTION
1. Fill fuel tank
2. Choked engine and attempt to restart
3. Wait several minutes before attempting to
restart.
4. Replace spark plug
5. Clean or replace air filter
6. Replace fuel filter
7. Drain fuel tank & carburetor, refill tank with
fresh gas and replace fuel filter
8. Check all wiring
9. See Engine Manual
10. Contact an authorized service center
11. See Engine Manual
12. Open
1. Replace spark plug
2. Clean or replace air filter
3. Replace fuel filter
4. Recharge or replace battery
5. See Engine Manual
6. Contact an authorized service center
7. Check all wiring
8. Drain fuel tank & refill with fresh gasoline
1. Place handles in the out most position
2. Push PTO switch down
3,
4.
5.
6.
7.
8.
Weak or dead battery
Blown fuse
Corroded battery terminals
Loose or damaged wiring
Faulty ignition switch
Faulty solenoid
3,
4.
5.
6,
7.
8.
Recharge or replace battery
Replace fusel
Clean battery terminals - See battery section
of this manual
Check all wiring
Check/replace ignition switch
Check/replace solenoid
1,
2.
3.
4.
1,
2.
1,
2.
3.
4.
Faulty operator presence switch/switches
Weak or dead battery
Corroded battery terminals
Loose or damaged wiring
Faulty solenoid
Incorrect tire pressure
Rear wheels rotating at different speeds.
Worn, bent or loose blade
Bent blade driver
Loose/damage part or parts
Faulty blade driver assembly
g, Contact an authorized service center
1. Recharge or replace battery
2. Clean battery terminals - See battery sectio
of this manual
3. Check all wiring
4. Check/replace solenoid
1. Check tire pressure (See Specifications)
2. Adjust travel reduction weldment.
1,
2.
3.
Replace blade. Tighten blade bolt.
Replace blade driver
Tighten loose part or parts. Replace
damaged parts.
Replace blade driver assembly
Loading ...
Loading ...
Loading ...