Loading ...
Loading ...
Loading ...
NATURAL GAS SAFETY
Your Natural Gas grill is designed to operate on natural gas ONLY, at a pressure of 4” water column (W.C.) regulated at the natural gas
regulator attached at the back of the grill. Check with your gas utility for local gas pressure and with your local municipality for building code
requirements.
Check with your gas utility or with local building codes for instructions to install gas supply line, or call a licensed and knowledgeable installer.
It is recommended that an ON-OFF” shutoff valve be installed at the gas supply source:
- Outdoors after gas line piping exits outside wall and before quick-disconnect or before gas line piping enters ground.
- Indoors in the branch fuel line in an accessible location near the supply line.
Pipe sealing compound or pipe thread tape of the type resistant to the action of natural gas must be used on all male pipe thread.
Apply compound or tape to at least the first three threads when making the connection.
This appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of
that system at pressures in excess of 1/2 psig (3.5 kPa).
This appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing
of the gas supply piping system at test pressures equal to or less than ½ psi (3.5kpa)
Turn off your gas grill when the gas supply is being tested at low pressures. This appliance must be isolated from the gas supply
piping system by closing its individual valve.
WARNING: Gas valves are preset at the factory to operate on LP or natural gas. If you wish to convert, be sure to contact your grill dealer
FIRST!
PROPANE GAS SAFETY
Your Propane gas grill is designed to operate on propane gas ONLY, at a pressure regulated at 11” water column (W.C.) when equipped
with the correct propane orifices on the valves and a propane regulator on the supply line regulated at the residential meter.
Your propane gas grill is designed to be used with a standard 20 lbs gas cylinder and must be constructed and marked in accordance
with specifications of the US Department of Transportation for Propane gas cylinders.
Always keep cylinder securely fastened in an upright position.
Never connect an unregulated propane gas cylinder to the grill.
Do not subject Propane cylinders to excessive heat.
CAUTION: Never store a Propane gas cylinder inside a building or in the vicinity of any gas-burning appliance.
WARNING: Gas valves are preset at the factory to operate on LP or Natural Gas. If you wish to convert, be sure to contact your grill dealer
FIRST!
SAFETY ! BEWARE OF SPIDERS
CAUTION: BURNER TUBES MUST BE INSPECTED AND CLEANED BEFORE FIRST USE.
Spiders and small insects occasionally spin webs or make nests in the burner tubes during warehousing and transit. These webs can lead
to a gas flow obstruction, which could result in a fire in and around the burner tubes. This type of fire is known as “FLASH-BACK” and can
cause serious damage to your grill and create an unsafe operating condition for the user. Although an obstructed burner tube is not the
only cause of “FLASH BACK‟ it is the most common cause, and frequent inspection and cleaning of the burner tubes is necessary.
5
Certificate 252521-2405769
Project 2405769
Figure No.(75)
Loading ...
Loading ...
Loading ...