Loading ...
Loading ...
Loading ...
3. WARRANTY 10. TROUBLESHOOTING
3.1 WARRANTY
Draper tools have been carefully tested and inspected before shipment and are guaranteed to be
free from defective materials and workmanship.
Should the tool develop a fault, please return the complete tool to your nearest distributor or
contact
Draper Tools Limited, Chandler's Ford, Eastleigh, Hampshire, SO53 1YF. England.
Telephone Sales Desk: (023) 8049 4333 or Product Help Line (023) 8049 4344.
A proof of purchase must be provided with the tool.
If upon inspection it is found that the fault occurring is due to defective materials or workmanship,
repairs will be carried out free of charge. This warranty period covering labour is 12 months from
the date of purchase except where tools are hired out when the warranty period is 90 days from
the date of purchase. The warranty is extended to 24 months for parts only. This warranty does not
apply to any consumable parts, any type of battery or normal wear and tear, nor does it cover any
damage caused by misuse, careless or unsafe handling, alterations, accidents, or repairs
attempted or made by any personnel other than the authorised Draper warranty repair agent.
Note: If the tool is found not to be within the terms of warranty, repairs and carriage charges will
be quoted and made accordingly.
This warranty applies in lieu of any other warranty expressed or implied and variations of its terms
are not authorised.
Your Draper warranty is not effective unless you can produce upon request a dated receipt or
invoice to verify your proof of purchase within the warranty period.
Please note that this warranty is an additional benefit and does not affect your statutory rights.
Draper Tools Limited.
The pump delivers
no water
The flow rate is too
low
The pump stops
running
1. The suction grid or piping
are clogged.
2. The impeller is worn or
stuck.
3. The head height exceeds
the pump specification.
4. Water level under the
suction minimum.
1. Make sure the suction
grid is not partially
clogged.
2. Make sure the impeller or
delivery pipe are not
partially clogged or fouled.
3. Flow direction control
valve orientation incorrect.
1. Intervention of the thermal
overload switch.
1. Remove the obstruction.
2. Replace the impeller or remove the
obstruction.
3. Reduce head height.
4. Insert into water or dig well to
move pump lower.
1. Remove any obstructions.
2. Remove any obstructions.
3. Check and replace if necessary.
1. Make sure the fluid being pumped
is not too dense, causing the motor
to overheat.
2. Make sure the temperature of the
water is not too high.
3. Make sure there is no solid body
obstructing the impeller.
4. Power supply doesn’t comply with
the nameplate’s data.
10.1 TROUBLESHOOTING CHECKLIST
WARNING:
For your own safety, always turn the main switch on the machine "Off" and remove the plug from
the power supply before carrying out any servicing or maintenance.
- 13 -
- 4 -
Loading ...
Loading ...
Loading ...