Loading ...
Loading ...
Loading ...
A
WARNING: Do not allow familiarity with products
to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
A
WARNING: Always wear safety goggles or safety
glasses with side shields when operating products.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
A
WARNING: Do not use any attachments or
accessories not recommended by the manufacturer
of this product. The use of attachments or
accessories not recommended can result in serious
personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
[] Drilling in wood
[] Drilling in ceramics, plastics, fiberglass, and laminates
[] Drilling in metals
[] Mixing paint
CAUTION: Ifat any point during the charging
process none of the LEDs are lit, remove the battery
pack from the charger to avoid damaging the
product. DO NOT insert another battery. Return the
charger and battery to your nearest Sears or other
qualified service center for service or replacement.
CHARGING THE BATTERY PACK
The battery pack for this product has been shipped in
a low charge condition to prevent possible problems.
Therefore, you should charge overnight prior to use.
NOTE: Batteries will not reach full charge the first time
they are charged. Allow several cycles (operation followed
by recharging) for them to become fully charged.
[] Charge battery pack only with the charging assembly
provided.
[] Make sure power supply is normal household voltage,
120 volts, 60 Hz, AC only.
[] Connect charger to power supply.
[] Place battery pack in charging stand. Align raised rib
on battery pack with groove in charging stand. See
Figure 2.
[] Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charging
stand.
[] The charge indicator light (LED), located on the
charging stand, will light up red and glow when the
charger is properly connected to power supply. This
light
indicates the charger is operating properly. It will
remain on until battery pack is removed from charging
stand or charger is disconnected from power supply.
[] After normal usage, 3 hours or less of charging time is
required to fully recharge battery pack.
NOTE: If both red and orange LED indicators glow, the
battery pack is deeply or completely discharged, and
6 hours or longer of charging time is required to fully
recharge the battery pack.
If the charger does not charge the battery pack, or
the orange LED continues to glow after more than
30 minutes of charging, return the battery pack and
charging assembly to your nearest Sears Repair Center
for electrical check.
[] The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
[] Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
[] When batteries become fully charged, unplug charger
from power supply and remove the battery pack.
CHARGING A HOT BATTERY PACK
When using your product continuously, the batteries in
your battery pack will become hot. You should let a hot
battery pack cool down for approximately 30 minutes
before attempting to recharge.
NOTE: This situation only occurs when continuous use
of this product causes the batteries to become hot.
It does not occur under normal circumstances. Refer
to "CHARGING THE BATTERY PACK" for normal
recharging of batteries. If the charging assembly does not
charge your battery pack under normal circumstances,
return both the battery pack and charging assembly to
your nearest Sears or other qualified service center for
electrical check.
10
Loading ...
Loading ...
Loading ...