Loading ...
Loading ...
Loading ...
snow blowing is accomplished when the
snow is removed immediately after it
falls,
• For complete snow removal, slightly over-
lap each path previousJy taken Use
more overlap in deep snow to prevent
overloading
• The snow should be discharged down
wind whenever possible. In windy condi-
tions, lower the chute deflector to direct
discharged snow close to the ground,
where it is less likely to blow into un-
wanted areas,
• For normal usage, set the skids so that
the scraper bar is 1/8" above the skids.
For extremely hard-packed snow sur-
faces, adjust the skids upward so that the
scraper bar touches the ground
• On gravel or crushed rock surfaces, set
the skids at 1-1/4" below the scraper bar
(See To Adjust Skids Height paragraph
on page 17)_Stones and gravel must not
be picked up and thrown by the machine
CUSTOMER RESPONSIBILITIES
. After the snow throwing job has been
completed, allow the engine to idle for a
few minutes, which will melt snow and
accumulated ice off the engine.
• Clean the snow thrower thoroughly after
each use
• Remove ice and snow accumulation and
a[I debris from the entire snow thrower,
and flush with water (if possible) to re-
move all salt or other chemicals. Wipe
snow thrower dry.
PRODUCT SPECIFICATIONS
HORSE POWER: 5.5 HP
DISPLACEMENT: 11.88 cu, in
GASOLINE CAPACITY: 4 quart
(unleaded)
OIL (20oz. Capacity) : 5W-30
SPARK PLUG: Champion RN4C
(Gap 030) or
Equivalent
VALVE CLEARANCE: Intake: .010 In.
Exhaust: .010 In.
SERVICE SCHEDULE
RECORDS
Fill in dates as After 8efor_ As Every Every
you complete first 2 Each Needa_ 10 25
regular service Hours Use Hours Hours
Each Before
Season Storage
SERVICE
DATES
=
Change Engine Oil Level
Change Engine Oil tJ
Tighten atl screws and nuts
Check Traction Clutch Cable
Adjustment (See cable Adj) fJ
Replace Spark Plug
Check Drive Botts
Lubricate all pivo! points
Check Auger Clutch Cable
Adjustment (See Cabte Adj} V 'r
Lubricate Disc Drive Plate Zerk
v" ,t !
, ,=,,,
v," v"
v" v"
v"
v"
v"
v,'
_ v" t
Loading ...
Loading ...
Loading ...