Loading ...
Loading ...
Loading ...
SERVICE & ADJUSTMENTS
Parking Brakes
,/The Swisher ZT2660 is equipped with a Parking Brake system activated by pulling the
brake knob (10) up.
,/Adjustment for the system is located on the ends of the brake weldment rod (18).
,/Raise the rear wheel off the ground.
,/Disengage the hydro to be adjusted with the hydro release handle at the rear of the
unit
,/Adjust so that the brake is not on when the handles are in the operator position. The
wheel should turn freely.
,/The wheel should not turn when the handle is move to the engaged or outward
position.
,/To tighten the brake, turn the adjustment nuts towards the end of the cable.
,/Recheck adjustment with control handle
,/Lower unit back to the ground
,/Reengage the hydro at the rear of the unit
25
ITEM #
]
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
DESC RIPTION PART #
Weldment; Rod Mounf -ZTR Brake 13190
Plaf e; Clasp - ZTR Brake 13191
Weld men t; Rod Piv of 13195
Weldment; ZTR Brake Linkaqe - Leff 13202
Weldmen t; ZTR Brake Linkaqe - R iqhf 13198
Spacer B99S
5/16-18 x 3/4 FLANGE BOLT NB596
5/16-18 SERR FLANGE NUT NB170
Weldment; Push Rod, ZTR Brake 13207
SHIFT KNOB B19
3/32 X 1 Coffer Pin NB708
1/4-20 Flanqe N uf N B524
5/16-18 Jam Nuf NB173
1/4-20 X 3/4 Flanqe (Self Cur tin q) NB690
TwoSpeed Sprinq (AZ32 1998) TZ2S
1/4 SAE Washer N B274
1/4-20 Nylok Nuf N B180
Weldment;Rod5/16-18x11 1/2;2 1/2 13208
Link- Clutch Chain T2L
Loading ...
Loading ...
Loading ...