Loading ...
Loading ...
Loading ...
page 5
5. Fan Assembly.
6. Wiring.
WARNING: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to
the OFF position.
CAUTION: Be sure outlet box is properly grounded and
that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the instructions below, please use a
qualified electrician.
Note: Excess lead wire length from the fan can be cut to
the desired length and then strip insulation ½ inch.
Locate 3 quick connect clips in hardware pack.
When fan is secured in place on the hanging bracket,
wire the fan using the provided clips:
Push BLACK wire from ceiling into clip. Then push
BLACK and BLUE wires from fan into same clip.
Push WHITE wire from ceiling into clip. Then push
WHITE wire from fan into same clip.
Push BARE/GREEN wire from ceiling into clip. Then
push GROUND (GREEN) wire from fan into same clip.
* Wrap each clip separately with electrical tape as an
extra safety measure.
IMPORTANT: Pull on each wire to make sure wires are
secure in the clip.
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging bracket
and let hanging ball rest on the hanging bracket. Turn
the hanging ball slot until it lines up with the hanging
bracket tab.
WARNING: Failure to align slot in hanging ball with
tab in hanging bracket may result in serious injury or
death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once
you are set on the ladder.
hanging ball slot
hanging bracket tab
black
black
from fan
from ceiling
white
white
blue
black supply wire
ground (green
or bare)
white supply wire
*
ground
(green or bare)
clip
clip
Loading ...
Loading ...
Loading ...