Loading ...
Loading ...
O _ _± 0 7
@ REMOVING DRAWERS
Empty the drawer.
Fully extend the drawer.
Release
@
iNSTALLiNG DRAWERS
Ball bearing slide - PuJJsJides and sJide carrier out to fuJJy
extended position (see illustration.) Hold the slide on the
cabinet while aligning it with the sJide on drawer. SJightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and rectose to ensure proper operation.
Slide carrier
Slide
Lever Style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the sJides to ride
over the stops). Putt out to remove.
/
Q
U
REMOVING AND INSTALLING SLIDES
, To remove the slide from the unit, first remove the
drawer.
After removing the drawer check to see if the unit has
rivets located on the front of the slide. To drill out rivets,
use a 5/32dn drill bit. The rivets witt need to be replaced
with 5/32dn rivets.
To reinstall the slide in the appropriate position in the
unit, align front and back lances with mounting holes in
the side of the unit. Pull towards the front of the unit and
downwards until rivet holes in slide tine up with holes in
the unit. The rivets will need to be replaced with 5/32dn
rivets.
- For smooth operation, make sure the drawers are
matched with their originaJ sJides.
Drill out rivet
Loading ...
Loading ...
Loading ...