Loading ...
Loading ...
Loading ...
For complete charging instructions, refer to the
Operator's Manual for your Craftsman battery
pack and charger models.
TO INSTALL / REMOVE BATTERY PACK
See figure 5.
WARNING: Always remove battery pack
from your tool when you are assembling
parts, making adjustments, cleaning, carry-
ing, transporting or when not in use. Re-
moving battery pack will prevent accidental
starting that could cause serious personal
injury.
NOTE: To avoid serious personal injury, always
remove the battery pack and keep hands
clear of the lock-out button when carrying or
transporting the tool.
To install:
[] Place the battery pack in your chain saw.
Align raised rib on battery pack with groove in
chain saw's battery port.
[] Make sure the latches on each side of
the battery pack snap in place and that
battery pack is secured in chain saw before
beginning operation.
To remove:
Locate latches on side of battery pack and
depress both sides to release the battery pack
from the chain saw.
CAUTION: When placing battery pack in
your chain saw, be sure raised rib on battery
pack aligns with groove in chain saw's battery
port and latches snap in place properly.
Improper assembly of battery pack can cause
damage to internal components.
CAUTION: Remove battery pack from
unit. Fill oil tank with Craftsman Bar and
Chain Lubricant before starting the chain
saw. Failure to lubricate the chain will cause
damage to the bar and chain.
CHAIN OIL SYSTEM
See figure 6.
[] Use Craftsman Bar and Chain Lubricant.
It is formulated to perform over a wide
temperature range with no dilution required.
NOTE: Do not use dirty, used or otherwise
contaminated lubricants. Damage may occur
to the bar or chain.
[] Carefully pour the bar and chain lubricant into
the tank.
[] Check and fill the oil tank when battery is
recharged, or as needed.
[] Depress the oil tank cap several times to
pump the lubricant to the chain before
starting the saw.
[] Depress the oil tank cap every 20-30 seconds
while cutting to keep the chain lubricated.
NOTE: It is normal for lubricant to seep from the
saw when not in use. To prevent seepage, empty
the oil tank after each use. When storing the unit
for a long period of time (three months or longer)
be sure the chain is lightly lubricated; this will
prevent rust on the chain and bar sprocket.
12 - English
Loading ...
Loading ...
Loading ...