Loading ...
Loading ...
Loading ...
6
Installation Instructions
Before Using Your Appliance:
Remove the exterior and interior packing.
Before connecting the unit to a power source, let it stand for approximately 2 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Remove the shelves and clean them and the interior surfaces of the unit with lukewarm
water using a soft cloth.
Installing the Refrigerator:
Place the unit on a floor that is strong enough to support it when the appliance is fully
loaded. To level the unit, adjust the two leveling legs at the front.
Your appliance is designed to be built into an enclosure. When installing, allow at least 2”
(51mm) of space at the sides, top and rear of the unit to allow for proper air circulation to
cool the compressor and condenser. Take care that the air vents at the front of the
appliance are never covered or blocked in any way.
This appliance is supplied with spacers which have to be mounted onto the condenser
tube at the back to make sure there is sufficient clearance between the appliance and the
wall.
Locate the unit away from direct sunlight and sources of heat (oven, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extremely cold ambient temperatures may also affect the unit's
performance.
Avoid locating the unit in moist areas. Too much moisture in the air will cause frost to
form quickly on the evaporator, requiring more frequent defrosting of the interior.
Plug the unit into an exclusive, properly installed and grounded wall outlet. Any questions
concerning power and/or grounding should be directed toward a certified electrician or
authorized service center.
Loading ...
Loading ...
Loading ...