Loading ...
Loading ...
Loading ...
Cleaning and maintenance
82
Programmed Vapor Clean cycle
Like for the normal cooking functions, it is
also possible to set an end time for the
Vapor Clean function.
1. After selecting the Vapor Clean function,
press the temperature knob. The
indicator light starts flashing. The display
shows the function end time.
2. Turn the temperature knob right or left to
delay the cooking end time.
3. Press the temperature knob to confirm the
function end time.
4. Press the function knob. The appliance
waits for the set start time.
End of the Vapor Clean cycle
At the end, is displayed and a
buzzer sounds.
1. To deactivate the buzzer, press or turn
one of the two knobs or open the door.
2. Press and hold the function knob for at
least 3 seconds to exit the function.
3. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
4. Use a non-scratch sponge with brass
filaments on hard to remove deposits.
5. In case of grease residues use specific
oven cleaning products.
6. Remove the residual water inside the
oven.
For improved hygiene and to avoid food
being affected by any unpleasant odours,
we recommend that the oven is dried using
a fan-assisted function at 160°C for
approximately 10 minutes.
4.6 Extraordinary maintenance
Removing and installing the door seal
(not on pyrolytic models)
To remove the seal:
• Unhook the clips located in the 4 corners
and in the centre, then pull the seal
outwards.
We recommend wearing rubber
gloves for these operations.
We recommend removing the
door in order to make the manual
cleaning of the parts that are
difficult to reach easier.
Loading ...
Loading ...
Loading ...