Loading ...
Removing the Filter Cartridge
If you are replacing the cartridge, first remove the old
one by slowly turning it to the left. Pull down gently on the
cartridge. A small amount of water may drip down.
CAUTION
To reduce the risk associated with
property damage due to water leakage, read and follow
instructions before installation and use of this system.
Installation and use MUST comply with all state and local
plumbing codes. The disposable filter cartridge should be
replaced every six months, at the rated capacity or sooner
if a noticeable reduction in flow rate occurs.
Installing the Filter Cartridge
1. On models without a replacement indicator light, apply
the month and year sticker to the new cartridge to
remind you to replace the filter in six months.
2. Fill the replacement cartridge with water from the tap to
allow for better flow from the dispenser immediately
after installation.
3. Line up the threads on the filter with corresponding
threads on the holder. Place the top of the new cartridge
up inside the holder. Do not push it up into the holder.
4. Slowly turn it to the right until the filter
cartridge stops. DO NOT
OVERTIGHTEN. As you turn the
cartridge, it will automatically raise itself
into position. The cartridge will move
about a 1/2 turn.
5. Run water from the dispenser for 4-1/2 gallons (about
five minutes) to clear the system and prevent sputtering.
6. LCD Models: Press FILTER REPLACED button to
confirm replacement.
Non-LCD Models: Press and hold the RESET WATER
FILTER pad (on some models) on the dispenser for
three seconds.
NOTE: A newly installed water filter cartridge may cause
water to spurt from the dispenser.
Filter bypass plug
To reduce the risk of property damage due to
water leakage, you MUST use the filter bypass
plug when a replacement filter cartridge is not
available. The dispenser and the icemaker will
not operate without the filter or filter bypass
plug.
Filter
Bypass
Plug
Cartridge
Holder
Removing/Installing Replacement Filter Cartridge
2
Loading ...
Loading ...