Loading ...
We recommend that only professional and expert installers
carry out the installation. As a bespoke artisan installation is
required, no cut-out pattern is provided.
We strongly recommend that you provide your installer with the
actual sink before the manufacture or modification of a cabinet. To
modify a standard cabinet so that it can accommodate and support
the weight of the farmhouse sink, a reinforcement must be built
inside it, by inserting a reinforced support surface.
When the sink is positioned on the support sructure, make sure that
the top of the sink reaches the bottom of the benchtop.
ATTENTION: check that the support structure is suitable for
this type of sink as its weight, including that of the water
it could contain, could exceed 70 kg. Reinforce the support
structure if needed. Minimum cabinet width 900mm.
The Farmhouse Sink is for UNDERMOUNT ONLY.
Step 1 Prepare the Sink Cabinet
To support the weight of the sink, prepare an internal support shelf
or a support structure.
Drill the drain hole on the support shelf (A), taking into account the
presence of the basket waste fitting. Prepare a hole in the rear area
for the water supply pipes (B).
Fit the strainer into the hole from the top,
and then place the drain under the hole.
Risk of personal injury. Composite sinks are heavy. Get help when lifting
or moving. Be sure to use proper tools and always wear personal safety
devices for your protection.
CAUTION
The internal support
shelf must be installed
at the preset height.
See Step 3
B
A
Basket
Screw
Strainer
Seal
Drain
1
2
3
4
5
INSTALLATION STEPS
SINK ASSEMBLY
Fasten the strainer to the drain using the
screw provided. Do not overtighten.
Tools needed for installation
Drain Parts
You MUST check the sink is NOT DAMAGED
before proceeding with installation.
Page 2 of 4
Loading ...
Loading ...