Loading ...
Loading ...
Loading ...
6 HUSKY INSTRUCTION MANUAL HUSKY INSTRUCTION MANUAL 7
SPECIFICATIONS
• This appliance is a wine storage appliance. It is not suitable for the storage of fresh
food or perishable drinks.
• It is intended strictly for domestic indoor use.
• The refrigerating circuit is leak-proof.
TO OPE RATE
• When the appliance has been positioned, adjust the feet to ensure the unit is stable. This
is essential to ensure quiet running and proper door opening/closing
• Ensure that the appliance is not connected to the power and clean the interior
compartment following the instructions on page 9
• Remove all transportation tapes
• CONNECT TO THE ELECTRICAL SOCKET BUT DO NOT SWITCH ON
THE POWER FOR AT LEAST 4 HOURS. The coolant within the product needs
time to settle after it has been transported and put in to position. Failure to do this will
affect the cooling performance of your appliance
• Follow the instructions below to adjust the thermostat to the required temperature.
• There may be an odour when you first switch on the appliance, it will disappear as it
starts to cool
• The following sounds are perfectly normal:
• Faint gurgling or bubbling sounds as the refrigerant is pumped to the cooling system
• A slight whirring or pulsating noise as the compressor is working
• A slight click as the thermostat cycles in and out and controls the compressor
• After the appliance has been unplugged, leave for 15 minutes before plugging it in again.
To turn the appliance ON or OFF, press the
button and hold for three seconds.
Setting the temperature control – single zone models
Temperature range choice is from 5–22°C on single zone models.
Press the button. The display will flash. You may adjust the internal temperature by
pressing the or buttons. The set temperature will increase by 1°C or 1°F each time
you press the button. Conversely the set temperature will decrease by 1°C or 1°F each
time you press the button.
Setting the temperature control – dual zone models
Temperature range choice is from 12–22°C (lower zone) and 5–12°C (upper zone) on dual
zone models.
Press the button. The display for the LOWER ZONE will flash, indicating you are setting
the temperature for the lower zone. If you press the button a second time the display for
the UPPER ZONE will flash, indicating you are setting the temperature for the upper zone.
For either zone, you may adjust the internal temperature by pressing the or buttons.
The set temperature will increase by 1°C or 1°F each time you press the button.
Conversely the set temperature will decrease by 1°C or 1°F each time you press the
button.
Recommended temperatures for chilling wine
Red wines: 14–18°C Rosé wines: 9–11°C
Dry/white wines: 10–13°C Sparkling wines: 5–8°C.
Notes
• If the unit is unplugged or power lost, you must wait at least 15 minutes before
restarting. If you attempt to restart the unit before this delay, the Wine Cooler may
not start.
• When you use the appliance for the first time or restart it after having been turned
off for a long time, there may be a few degrees difference between the temperature
you select and the one indicated on the LED readout. This is normal. Once the cooler
has been running for a few hours the display will stabilise.
WARNING
If the thermostat is set to too cold a setting, beverages may become frozen. In extreme
circumstances, glass bottles may even break. Always exercise caution when setting the
temperature.
1. Control panel
2. Ventilation fan
3. Glass door
4. Door seal
5. Lock bracket
6. Upper hinge
7. Active carbon filter
8. Sensor
9. Sliding shelf runner
10. Shelf
11. Ventilation grille
12. Adjustable feet
Loading ...
Loading ...
Loading ...