Loading ...
Loading ...
Loading ...
18
Locating the Filter
Your refrigerator is equipped with a water
ltering system. The water lter system lters
all dispensed drinking water, as well as the
water used to produce ice.
Water Filter
The water lter is located at the top right side
of the fresh food compartment.
Ordering Replacement Filters
To order your replacement lters, please
contact manufacturer.
Here are the product numbers to request when
ordering:
PureSource 3
TM
Water Filter
Part #WF3CB
Replacing the Water Filter
In general, you should change the water
lter every six months to ensure the highest
possible water quality. Water Filter Status
on the user interface prompts you to replace
the lter after a standard amount of water
(200 gallons/757 liters for PureSource 3
TM
)
has owed through the system.
If your refrigerator has not been used for a
period of time (during moving for example),
change the lter before reinstalling the
refrigerator.
Filter Cartridge
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certied for cyst reduction may be used on
disinfected waters that may contain lterable cysts.
Test & certication results:
• Rated Capacity - 200 gallons/757 liters for
PureSource 3
TM
ice and water lter
• Rated service ow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace your PureSource 3
TM
water
lter:
It is not necessary to turn the water supply off
to change the lter. Be ready to wipe up any
small amounts of water released during the
lter replacement.
1 Turn Off the ice maker.
2 Remove the lter by pushing on the end/
face of the lter.
3 Slide the old water lter cartridge straight
out of the housing and discard it.
4 Unpackage the new lter cartridge. Using
the alignment guide, slide it gently into the
lter housing until it stops against the snap-
in connector at the back of the housing.
5 Push rmly until the cartridge snaps into
place (you should hear a click as the
cartridge engages the snap-in connector).
6 Press a drinking glass against the water
dispenser while checking for any leaks at
the lter housing. Any spurts and sputters
that occur as the system purges air out of
the dispenser system are normal.
7 After lling one glass of water, continue
ushing the system for about four minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from
“Red” to “Green,” the status has been reset.
The PureSource 3
TM
ice and water
lter system is tested and certied
to NSF/ANSI Standards 42 and 53
for the reduction of claims specied
on the performance data sheet.
More about your Advanced
Water Filter
CHANGING THE FILTER
Loading ...
Loading ...
Loading ...