Loading ...
Loading ...
Loading ...
BELT GUIDE ADJUSTMENT
1. Remove spark plug wire.
2. Have someone engage auger drive.
3. Measure the distance between the
belt guide and belt. The distance
should be 1/8 inch (3.175 ram) for
guide. See Figure 42.
position of fitting to hole in clutch le-
ver.
"Z" Fitting
Auger Idler
Pulley LC;J
Engaged
Belt Guide
1/8 Inch
(3.175 ram)
Figure42
4. If adjustment is necessary, loosen
belt guide mounting bolt. Move belt
guide to the correct position. Tight-
en mounting bolt.
5. Reinstall belt cover.
6. Reconnect spark plug wire.
HOW TO CHECK AND AD-
JUST THE CABLES
The cables are adjusted at the factory
and no adjustment should be neces-
sary. If the cables have become
stretched or are sagging adjustment will
be necessary.
Whenever belts are adjusted or re-
placed, the cables will need to be ad-
justed.
To check for correct adjustment, un-
hook "Z" fitting at clutch lever (see
Figure 43)
1. Move clutch lever to the full forward
position (just contacting plastic
bumper). Holding cable tight, note
F-O11068L
Figure 43
2. The center of the "Z" fitting should
be between the center and top of
the hole in the clutch lever. Adjust
either the auger drive cable or the
traction drive cable as follows.
Auger Drive Cable Adjustment
_ ARNING: Drain the gaso-
line outdoors, away from
fire or flame.
1. Remove the gas from the gas tank.
Stand the snow thrower up on the
front end of the auger housing.
2. Push cable through spring to ex-
pose the threaded portion of the
cable (see Figure 44).
Square
End
Cable Spring
Locknut
Figure 44
27
3. Hold square end of threaded portion
with pliers and adjust Iocknut in or
out until correct adjustment is
reached. Pull cable back through
spring and connect cable.
Loading ...
Loading ...
Loading ...