Loading ...
Loading ...
Loading ...
INDEX LEVER IN THE NOTCH MARKED "90"
TO USE CURB-HOPPING FEATURE
The adjustable front and right rear wheel
feature permit the Edger/Trimmer to be
used on an uneven surface such as a curb
as shown in figure below.
• Stop the engine and disconnect the
spark plug wire from the spark plug.
• Loosen the knob on the front wheel arm
bracket and slide the wheel to the best
position to clear the curb and balance the
unit.
• Tighten the knob securely.
• Using the curb height adjust lever, lower
the front wheel to a position that places
the Edger/Trimmer level with the left rear
wheel on the uneven curb surface.
• Loosen tee knob on the inside right rear
of the main frame that secures the wheel
support rod as shown below.
• Slide the rear wheel down until the
Edger/Trimmer is level when the left
wheel is on the curb.
• Tighten the knob securely.
Tee Knob
(Behind _
Wheel)
Blade
Knob
Wheel
Rod Adjust Lever
• Reconnect the spark plug wire and start
the engine. The depth of cut adjustment
is the same as described in Edging
Operation paragraph.
•iK CAUTION: Keep away from the
rotating blade. The blade can cause injury.
BEFORE STARTING ENGINE
PRE_.USECHECK OF CONTROLS
All controls should be checked for proper
function before servicing or starting the
engine.
• Move the clutch lever into all six
positions in the selector plate. Make
sure the clutch lever snaps into all six
holes.
• Return the clutch lever to the rearmost
hole in the selector plate.
FILIJADD OIL:
This Edger/Trimmer was shipped with a 20
ounce container of SAE30 motor oil. This
oil must be added to the engine before
operating. Remove the oil fill cap/dipstick
to fill the crankcase. DO NOT OVERFILL.
NOTE: Engine may already contain some
residual oil. Check frequently when filling
the crankcase.
OIL RECOMMENDATIONS
Only use high quality detergent oil rated
with API service classification SG. Select
the oil's SAE viscosity grade according to
your expected operating temperature.
A{though mu{ti-viscosity oils (5W30, 10W30,
etc.) improve starting in cold weather, these
multi-viscosity oils will result in increased oil
consumption when used above 32°F.
Check your engine oil level more frequently
to avoid possible engine damage from
running low on oil.
Colder << 32°F _ >>Warmer ]
,"- w3o" t-- 3o "
{
TO ADD ENGINE OIL
• Place the Edger/Trimmer on a level
surface.
• Remove the oil fill cap/dipstick.
• Fill the engine crankcase, poudng slowly.
DO NOT OVERFILL. For approximate
capacity see PRODUCT SPECIFICA-
TIONS chart in this manual.
Loading ...
Loading ...
Loading ...