Loading ...
Loading ...
Loading ...
OPERATION
INSTALL1NG/REMOVING CUTTERS
See Figure2,
t+ UNPLUGYOUR ROUTER+
2. A Spindle lock is located on the front of the motor
housing See Figure 1, To activate lock, push spindle
lock tn and slide into lock position,
3.
Place your muter upside down on tab{e, then turn collet
nut with wrench until lock mechanism interlocks See
Figure 2. NOTE: Spindle lock is spring loaded and will
snap into position when lock mechanism interlocks,
4.
6_
Remove cutters by turning coliet nut counterclockwise
enough to allow cutter to slip easily from colleL See
Figure2, The cotlet is machined to precision tolerances
to fit cutters with I/4" diameter shank size+
With your router sti+l upside down on table, insert shank
of cutter into collet LThe shank of your cutter shoMd be
close to but not touching bottom of cotter+
Tighten the coltet nut securely by turning clockwise with
the wrench provided+ See Figure 2 Put spindle lock
back in unlock positlon+ Otherwise, the interlocking
mechanism of the spindle lock will not let you turn your
router oR.
DEPTHOF CUT ADJUSTMENTS
See Figures 3 and 4
We recommend thai cuts be made at a depth not exceeding
1/8" and that several passes be made to reach depths ofcut
greater than 1/8"
TURN TO ACTIVATE
SPINDLE LOCK
CUTTER
TO LOCK
Fig. 2
TO UNLOCK
CLAMPING
LEVER
ELECTRICAL CONNECTION
Your router has a precision built electric motor+ ft should be
connected to a power supply that is 120 volts, 60 Hz, AC
only (normal household current). Do not operate this tool
on direct current (DC) A voltage drop of more than 10
percent will cause a loss of power and overheating If your
tool does not operate when plugged into an oulIet, double-
check the power supply rating
Page 5
Loading ...
Loading ...
Loading ...