Loading ...
Loading ...
Loading ...
At Krowne Metal Corporation (KMC) we are dedicated to customer satisfaction. This installation guide is
provided to clarify and answer any questions you may have regarding our line of Slide Top Bottle Coolers.
Please read this guide before attempting installation or operation. Thank you for choosing KMC as your Bottle
Cooler provider.
UNCRATING
Remove all shipping material from unit before operation. Please inspect unit for any hidden freight damage and
report any damage immediately to Krowne Metal Corp. If included, install optional casters or legs to bottom of
unit. Please avoid turning unit on it’s side or rear to install accessories. If this can not be avoided, unit must be
left in the upright position for 24 hrs before operating. All units come equipped with pre-determined mounting
holes and self starting screws for easy install. (screws are provided only when casters or legs are ordered from
factory). It is important to check that casters or legs are securely attached with appropriate mounting
hardware.
ELECTRICAL REQUIREMENTS
115 Volt AC, 1 Phase, 60Hz. We recommend using a dedicated 15 amp circuit minimum. 8’-0”grounded cord
standard. ** DO NOT PLUG UNIT INTO A GFI OUTLET **
PLUMBING
All units have an evaporating pan and do not require any plumbing hook-up.
INSTALLING OF DIVIDERS
Dividers come pre-installed at the factory. Additional racks can be ordered and placed as per customer’s
request.
LOCATION
Place unit in desired location and level. Allow 2” clearance on left side or at rear of unit for proper air ow (both
recommended). DO NOT BLOCK OR OBSTRUCT FRONT GRILL.
FLOOR SEALING
If desired, unit can be sealed to oor using a NSF approved clear silicone. Excess sealant should be wiped
clean.
Krowne Metal Corporation
100 Haul Rd. Wayne, NJ 07470 • Toll Free: (800) 631-0442 • Fax: (973) 872-1129
[email protected] • www.krowne.com • www.facebook.com/KrowneMetal • www.twitter.com/KrowneMetal
4
INSTALLATION
Loading ...
Loading ...
Loading ...